Vi tager imod kryptovaluta — så den krypto, du ejer, kan købe rigtig hardware.Betal med krypto, brug det på rigtig hardware. Gratis, forsikret levering til hele verden ved køb over 399 $. Neutrale, umærkede papkasser, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Din kurs låses i 30 minutter, så snart kassen åbner.Kurs låst i 30 minutter. Hver vare er forseglet, har kontrolleret serienummer og er dækket af 24 måneders garanti.Forseglet, 24 måneders garanti.

Prisvagt Log ind
Two green DDR4 SODIMM sticks side by side

NEMIX RAM

NEMIX RAM 16GB (2x8GB) DDR4 2400 CL17 260-Pin SODIMM

SKU CH-DNWT-4RR52

A 16 GB dual-channel DDR4 kit running at 2400 MT/s with CL17 latency and 1.2 V for laptops and small-form-factor systems

  • Capacity16GB (2 x 8GB)
  • Type260-Pin DDR4 SO-DIMM
  • SpeedDDR4 2400 (PC4 19200)
  • CAS LatencyCL17
  • Voltage1.20V
  • ECCNo

Capacity 16GB (2 x 8GB)

  • 16GB (2 x 8GB)
  • 8GB
  • 16 GB dual-channel kit doubles usable memory bandwidth
  • DDR4 2400 MT/s rating matches PC4-19200 system requirements
  • CL17 latency at 1.20 V keeps power draw low
  • 260-pin SODIMM form factor fits laptops, AIOs and SFF devices
  • Non-ECC unbuffered design installs without configuration changes

Dual-channel DDR4 laptop kit

This 16 GB kit contains two 8 GB SODIMM modules built for laptops, all-in-one PCs, small-form-factor desktops and compatible NAS devices. Each stick runs at DDR4 2400 with a CL17 latency and 1.20 V operation. The 260-pin form factor fits standard SO-DIMM slots in supported systems.

Suits dual-slot DDR4 upgrades

Buyers whose machine has two SO-DIMM slots and supports DDR4 2400 memory will gain the full dual-channel benefit from this matched pair. Systems with only one memory slot or that require a different DDR generation cannot use this kit. Builders needing ECC or registered modules should select a different product.

260-pin DDR4 SO-DIMM interface

The kit uses the 260-pin DDR4 SO-DIMM interface, so it only installs in slots wired for that exact standard. Verify the platform manual before purchase to confirm DDR4 2400 support and available slot count.

Fordele

  • 16 GB dual-channel kit doubles usable memory bandwidth
  • DDR4 2400 MT/s rating matches PC4-19200 system requirements
  • CL17 latency at 1.20 V keeps power draw low
  • 260-pin SODIMM form factor fits laptops, AIOs and SFF devices
  • Non-ECC unbuffered design installs without configuration changes

Specifikationer

BrandNEMIX RAM
SeriesNEMIX RAM DDR4 Orignial Series 260-Pin NON-ECC Unbuffered SODIMM Memory
ModelDDR4 NON-ECC Unbuffered SODIMM Laptop, AIO, SFF, NAS Storage Device Memory
Part NumberMS19200-828K2
Capacity16GB (2 x 8GB)
Type260-Pin DDR4 SO-DIMM
SpeedDDR4 2400 (PC4 19200)
CAS LatencyCL17
Voltage1.20V
ECCNo
Buffered/RegisteredUnbuffered
Heat SpreaderNo
FeaturesDDR4 Laptop, AIO All-in-One, SFF, NAS Device Compatible

Andre versioner af denne model

5 flere i samme serie

Samme familie, men med anden hukommelse, køler eller clockfrekvens — sammenlign, før du bestemmer dig.

Spørgsmål om denne vare

Do I need a laptop or SFF system with a DDR4 SO-DIMM slot that accepts 260-pin unbuffered non-ECC modules?

Yes, this kit requires a DDR4 SO-DIMM slot supporting 260-pin unbuffered non-ECC memory at 1.20V; the motherboard must accept 2Rx8 organisation.

Will the kit run at its rated 2400MHz CL17 if I keep older DDR4 modules installed alongside it?

The system will operate all modules at the speed and timing of the slowest installed kit; mixing speeds or latencies forces the faster modules to downclock.

How can I confirm the 16GB kit is detected at 2400MHz CL17 after installation?

Check the memory speed and CAS latency in the BIOS or UEFI, or use a system-information tool such as CPU-Z to verify 2400MT/s and CL17 timings.

Også på denne hylde

Kunderne har også sammenlignet disse

Samme hylde, samme kasse — otte mønter og 30 minutters kurslås.