Vi tager imod kryptovaluta — så den krypto, du ejer, kan købe rigtig hardware.Betal med krypto, brug det på rigtig hardware. Gratis, forsikret levering til hele verden ved køb over 399 $. Neutrale, umærkede papkasser, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Din kurs låses i 30 minutter, så snart kassen åbner.Kurs låst i 30 minutter. Hver vare er forseglet, har kontrolleret serienummer og er dækket af 24 måneders garanti.Forseglet, 24 måneders garanti.

Prisvagt Log ind

NEMIX RAM

NEMIX RAM 32GB (2x16GB) DDR5 5600 CL46 1.1V ECC RDIMM Supermicro H14DST-F

SKU CH-BJ8M-9T8DC

32 GB dual-rank DDR5-5600 ECC registered kit validated for Supermicro H14DST-F

  • Capacity32GB (2 x 16GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes
  • 32 GB capacity from two 16 GB modules for full population
  • DDR5 5600 speed with CL46 latency runs at rated frequency
  • 1 V registered ECC design reduces controller load and corrects errors
  • 288-pin RDIMM form factor matches Supermicro H14DST-F slot requirements
  • Major OEM Samsung Micron Hynix chips deliver enterprise-grade reliability

Exact-match DDR5 ECC RDIMM kit

This 32 GB kit contains two 16 GB DDR5 5600 registered ECC modules built to the precise rank, voltage and timing the Supermicro H14DST-F memory controller expects. It installs as a matched pair so the board recognises the full capacity at rated speed without manual configuration.

32 GB capacity with registered buffering

The 1Rx8 organisation and 1.1 V operation let every populated slot run at the full 5600 MT/s data rate while the registered architecture reduces electrical load on the controller. ECC corrects single-bit errors on the fly, preventing silent data corruption in production workloads.

288-pin RDIMM form factor for server boards

These modules fit only motherboards that accept 288-pin registered DDR5 DIMMs; they will not work in UDIMM or SODIMM slots. Consult the system manual for approved population order and maximum supported capacity before installation.

Fordele

  • 32 GB capacity from two 16 GB modules for full population
  • DDR5 5600 speed with CL46 latency runs at rated frequency
  • 1 V registered ECC design reduces controller load and corrects errors
  • 288-pin RDIMM form factor matches Supermicro H14DST-F slot requirements
  • Major OEM Samsung Micron Hynix chips deliver enterprise-grade reliability

Specifikationer

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-618K2
Capacity32GB (2 x 16GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content32GB 2X16GB DDR5 5600MHz PC5-44800 1Rx8 1.1V 288-PIN ECC RDIMM KIT

Andre versioner af denne model

5 flere i samme serie

Samme familie, men med anden hukommelse, køler eller clockfrekvens — sammenlign, før du bestemmer dig.

Spørgsmål om denne vare

Will this DDR5 5600 CL46 ECC RDIMM kit run at its rated speed alongside existing DDR5 modules in my Supermicro H14DST-F?

The kit matches the board's required DDR5-5600, 1.1V, CL46, 1Rx8 registered specification so the memory controller will recognise each 16 GB module at full capacity and rated speed when populated per the motherboard manual.

How can I confirm the 32 GB kit is operating correctly after installation?

Enter the system BIOS or use a hardware monitoring utility to verify the memory reports 32 GB total, DDR5-5600 frequency, CL46 timings, 1.1 V voltage and ECC active status.

What comes in the box and is anything else required for installation?

The package contains the 32 GB (2 × 16 GB) DDR5 5600 CL46 1.1 V ECC registered RDIMM kit only; no heat spreaders, cables or additional hardware are included.

Også på denne hylde

Kunderne har også sammenlignet disse

Samme hylde, samme kasse — otte mønter og 30 minutters kurslås.