BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Δεχόμαστε κρυπτονομίσματα — έτσι ώστε αυτά που κατέχετε να μπορούν να αγοράσουν πραγματικό εξοπλισμό.Πληρώστε σε κρυπτονομίσματα, ξοδέψτε τα σε πραγματικό εξοπλισμό. Δωρεάν ασφαλισμένη αποστολή παγκοσμίως άνω των 399 $. Ουδέτερες κούτες αποστολής, χωρίς σήμανση, από τη Γερμανία.Δωρεάν ασφαλισμένη αποστολή άνω των 399 $. Η ισοτιμία σας κλειδώνει για 30 λεπτά μόλις ανοίξει το ταμείο.Κλείδωμα ισοτιμίας 30 λεπτών. Κάθε προϊόν είναι σφραγισμένο, ελεγμένο ως προς τον σειριακό αριθμό του, και καλύπτεται από εγγύηση 24 μηνών.Σφραγισμένο, με εγγύηση 24 μηνών.
SK hynix
8 GB DDR4 SODIMM with 1Rx16 organisation runs at 3200 MHz, CL22 latency and 1.2 V
This SK hynix module delivers 8 GB of DDR4 memory in a 260-pin SO-DIMM stick designed for laptop upgrade slots. It operates at 3200 MHz with a CL22 latency and runs on the standard 1.2 V supply for DDR4 SO-DIMM platforms. The unbuffered, non-ECC design matches the requirements of most consumer notebooks. No heat spreader is fitted, keeping the profile low for tight chassis clearances.
The single 8 GB stick suits owners adding memory to a free slot or replacing a failed module in a DDR4 SO-DIMM laptop. Buyers who need more than 8 GB total capacity should consider a multi-module kit or higher-density sticks. Systems that require ECC or registered memory cannot use this unbuffered module. Laptops limited to lower DDR4 speeds will run the module at the slower supported rate.
The bus speed is rated PC4-25600 (DDR4-3200) with CL22 timing, and this is the figure that determines whether the module matches the laptop's memory controller specification. Check the manufacturer's qualified-vendor list or manual for DDR4-3200 CL22 support before ordering. If the platform only qualifies faster timings or a different voltage, this module may not operate at its rated speed.
| Brand | Hynix |
|---|---|
| Series | Notebook Memory |
| Model | HMAA1GS6CJR6N-XN |
| Capacity | 8GB |
| Type | 260-Pin DDR4 SO-DIMM |
| CAS Latency | CL22 |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Heat Spreader | No |
The module uses the standard 260-pin DDR4 SO-DIMM form factor and 1.2 V operation, so it fits any laptop slot designed for DDR4 SO-DIMMs.
Align the notch with the slot key, insert at a slight angle, then press down firmly until both side clips click; the step often missed is verifying both clips have fully engaged.
No firmware updates are required for this memory; it is a solid-state component with no moving parts and no user-serviceable items, so no scheduled maintenance or replacement parts are needed.
Επίσης σε αυτό το ράφι
Ίδιο ράφι, ίδιο ταμείο — οκτώ νομίσματα και κλείδωμα ισοτιμίας 30 λεπτών.
Το νόμισμα στο οποίο πληρώνετε, και αυτό στο οποίο βλέπετε τις τιμές.
Αποστέλλεται από το πορτοφόλι σας στο ταμείο
Μόνο για προβολή — ο κατάλογος αναγράφεται σε δολάρια
Κανένα νόμισμα δεν αντιστοιχεί.
Επιλέξτε τη γλώσσα στην οποία σας μιλάει ο ιστότοπος.
Καμία γλώσσα δεν ταιριάζει.
Πρώτη επίσκεψη;
Έχετε ήδη λογαριασμό;
Δεν υπάρχει αυτόματη επαναφορά κωδικού: αυτό το κατάστημα δεν στέλνει e-mail, άρα δεν υπάρχει σύνδεσμος μίας χρήσης να ζητήσετε. Αφήστε τη διεύθυνση στον λογαριασμό σας και κάποιος θα την επεξεργαστεί με το χέρι.
Το αίτημα καταχωρίστηκε
Δεν θα λάβετε τίποτα στα εισερχόμενά σας — το κατάστημα δεν στέλνει κανένα e-mail. Κάποιος το διαχειρίζεται με το χέρι.
Τον θυμηθήκατε;