BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.
SK hynix
8 GB DDR4 SODIMM with 1Rx16 organisation runs at 3200 MHz, CL22 latency and 1.2 V
This SK hynix module delivers 8 GB of DDR4 memory in a 260-pin SO-DIMM stick designed for laptop upgrade slots. It operates at 3200 MHz with a CL22 latency and runs on the standard 1.2 V supply for DDR4 SO-DIMM platforms. The unbuffered, non-ECC design matches the requirements of most consumer notebooks. No heat spreader is fitted, keeping the profile low for tight chassis clearances.
The single 8 GB stick suits owners adding memory to a free slot or replacing a failed module in a DDR4 SO-DIMM laptop. Buyers who need more than 8 GB total capacity should consider a multi-module kit or higher-density sticks. Systems that require ECC or registered memory cannot use this unbuffered module. Laptops limited to lower DDR4 speeds will run the module at the slower supported rate.
The bus speed is rated PC4-25600 (DDR4-3200) with CL22 timing, and this is the figure that determines whether the module matches the laptop's memory controller specification. Check the manufacturer's qualified-vendor list or manual for DDR4-3200 CL22 support before ordering. If the platform only qualifies faster timings or a different voltage, this module may not operate at its rated speed.
| Brand | Hynix |
|---|---|
| Series | Notebook Memory |
| Model | HMAA1GS6CJR6N-XN |
| Capacity | 8GB |
| Type | 260-Pin DDR4 SO-DIMM |
| CAS Latency | CL22 |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Heat Spreader | No |
The module uses the standard 260-pin DDR4 SO-DIMM form factor and 1.2 V operation, so it fits any laptop slot designed for DDR4 SO-DIMMs.
Align the notch with the slot key, insert at a slight angle, then press down firmly until both side clips click; the step often missed is verifying both clips have fully engaged.
No firmware updates are required for this memory; it is a solid-state component with no moving parts and no user-serviceable items, so no scheduled maintenance or replacement parts are needed.
Tudi v tem oddelku
Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.
V čem plačujete in v čem berete cene.
Poslano iz Vaše denarnice ob blagajni
Samo za prikaz — katalog je cenovno izražen v dolarjih
Nobena valuta ne ustreza.
Izberite jezik, v katerem Vam govori spletna stran.
Ni ustreznega jezika.
Prvič tu?
Že imate račun?
Samodejne ponastavitve ni: ta trgovina ne pošilja e-pošte, zato ni enkratne povezave, ki bi jo lahko zahtevali. Pustite naslov na računu — nekdo ga bo obravnaval ročno.
Zahteva zabeležena
V Vašo elektronsko pošto ne prihaja nič — ta trgovina ne pošilja nobene e-pošte. Zahteve nekdo obravnava ročno.
Ste se spomnili?