BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.
SK hynix
8 GB DDR4 SODIMM with 1Rx16 organisation runs at 3200 MHz, CL22 latency and 1.2 V
This SK hynix module delivers 8 GB of DDR4 memory in a 260-pin SO-DIMM stick designed for laptop upgrade slots. It operates at 3200 MHz with a CL22 latency and runs on the standard 1.2 V supply for DDR4 SO-DIMM platforms. The unbuffered, non-ECC design matches the requirements of most consumer notebooks. No heat spreader is fitted, keeping the profile low for tight chassis clearances.
The single 8 GB stick suits owners adding memory to a free slot or replacing a failed module in a DDR4 SO-DIMM laptop. Buyers who need more than 8 GB total capacity should consider a multi-module kit or higher-density sticks. Systems that require ECC or registered memory cannot use this unbuffered module. Laptops limited to lower DDR4 speeds will run the module at the slower supported rate.
The bus speed is rated PC4-25600 (DDR4-3200) with CL22 timing, and this is the figure that determines whether the module matches the laptop's memory controller specification. Check the manufacturer's qualified-vendor list or manual for DDR4-3200 CL22 support before ordering. If the platform only qualifies faster timings or a different voltage, this module may not operate at its rated speed.
| Brand | Hynix |
|---|---|
| Series | Notebook Memory |
| Model | HMAA1GS6CJR6N-XN |
| Capacity | 8GB |
| Type | 260-Pin DDR4 SO-DIMM |
| CAS Latency | CL22 |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Heat Spreader | No |
The module uses the standard 260-pin DDR4 SO-DIMM form factor and 1.2 V operation, so it fits any laptop slot designed for DDR4 SO-DIMMs.
Align the notch with the slot key, insert at a slight angle, then press down firmly until both side clips click; the step often missed is verifying both clips have fully engaged.
No firmware updates are required for this memory; it is a solid-state component with no moving parts and no user-serviceable items, so no scheduled maintenance or replacement parts are needed.
Aj v tomto oddelení
Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.
Mena, v ktorej platíte, a mena, v ktorej sa zobrazujú ceny.
Odoslané z vašej peňaženky na pokladni
Len na zobrazenie — katalóg je uvedený v dolároch
Žiadna mena nezodpovedá.
Vyberte jazyk, v ktorom s vami bude web komunikovať.
Žiadny jazyk nezodpovedá.
Ste tu prvýkrát?
Účet už máte?
Automatický reset hesla neexistuje: tento obchod neposiela žiadne e-maily, takže neexistuje jednorazový odkaz, o ktorý by ste mohli požiadať. Nechajte adresu na účte — niekto sa jej ujme ručne.
Žiadosť zaznamenaná
Do vašej schránky nič nepríde — tento obchod neposiela vôbec žiadne e-maily. Niekto sa o to postará ručne.
Spomenuli ste si?