BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.
SK hynix
8 GB DDR4 SODIMM with 1Rx16 organisation runs at 3200 MHz, CL22 latency and 1.2 V
This SK hynix module delivers 8 GB of DDR4 memory in a 260-pin SO-DIMM stick designed for laptop upgrade slots. It operates at 3200 MHz with a CL22 latency and runs on the standard 1.2 V supply for DDR4 SO-DIMM platforms. The unbuffered, non-ECC design matches the requirements of most consumer notebooks. No heat spreader is fitted, keeping the profile low for tight chassis clearances.
The single 8 GB stick suits owners adding memory to a free slot or replacing a failed module in a DDR4 SO-DIMM laptop. Buyers who need more than 8 GB total capacity should consider a multi-module kit or higher-density sticks. Systems that require ECC or registered memory cannot use this unbuffered module. Laptops limited to lower DDR4 speeds will run the module at the slower supported rate.
The bus speed is rated PC4-25600 (DDR4-3200) with CL22 timing, and this is the figure that determines whether the module matches the laptop's memory controller specification. Check the manufacturer's qualified-vendor list or manual for DDR4-3200 CL22 support before ordering. If the platform only qualifies faster timings or a different voltage, this module may not operate at its rated speed.
| Brand | Hynix |
|---|---|
| Series | Notebook Memory |
| Model | HMAA1GS6CJR6N-XN |
| Capacity | 8GB |
| Type | 260-Pin DDR4 SO-DIMM |
| CAS Latency | CL22 |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Heat Spreader | No |
The module uses the standard 260-pin DDR4 SO-DIMM form factor and 1.2 V operation, so it fits any laptop slot designed for DDR4 SO-DIMMs.
Align the notch with the slot key, insert at a slight angle, then press down firmly until both side clips click; the step often missed is verifying both clips have fully engaged.
No firmware updates are required for this memory; it is a solid-state component with no moving parts and no user-serviceable items, so no scheduled maintenance or replacement parts are needed.
Veel samast osakonnast
Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.
See, millega maksate, ja see, milles vaatate hindu.
Saadetud teie rahakotist kassas
Ainult kuvamiseks — kataloogi hinnad on dollarites
Ükski vääring ei vasta sellele.
Valige keel, milles sait teiega räägib.
Ükski keel ei vasta.
Esimest korda siin?
Teil on juba konto?
Automaatset lähtestamist ei ole: see pood ei saada ühtegi e-kirja, seega pole ka ühekordset linki, mida küsida. Jätke aadress kontole alles, seda käsitletakse käsitsi.
Päring registreeritud
Teie postkasti ei jõua midagi — see pood ei saada e-kirju üldse. Keegi tegeleb sellega käsitsi.
Tuli meelde?