Square black frame fan with four-pin connector and centre label

SXDOOL

SXDOOL PVA120G12U 120mm 12025 PWM case fan

SKU CH-8VQH-NMA8C

A 120 mm PWM case fan with a 25 mm frame, four-wire connector and 12 V 0.75 A power draw

TypeCase Fan

120 mm frame fits standard case mounts
25 mm depth suits typical clearance
PWM 4-pin header enables speed control
12 V 0.75 A rating delivers reliable airflow
Foxconn build quality supports continuous operation

15,99 $

0.0002028 BTC με τη σημερινή ισοτιμία

Διαθέσιμο · αποστολή σήμερα

Το ταμείο κλειδώνει την ισοτιμία σας για 30 λεπτά.

Παράδοση προς Ηνωμένες Πολιτείες εκτίμηση

UPS Worldwide Expedited 3–6 εργάσιμες ημέρες 39,90 $
DHL Express Worldwide 2–3 εργάσιμες ημέρες 74,90 $

Προσθέστε 383,01 $ ακόμη και η βασική αποστολή γίνεται δωρεάν.

Οι εισαγωγικοί δασμοί επιβάλλονται κατά την άφιξη από τη χώρα σας.

Αποστολή αλλού

Foxconn 120mm PWM case fan

The Foxconn PVA120G12U is a 120mm square frame case fan measuring 25mm thick. It runs on 12V DC at 0.75A and uses a 4-wire 4-pin PWM connector for speed control. This unit is built for standard chassis cooling positions.

Suits builders fitting a single 12025 PWM slot

It fits any case or cooler mount that accepts a 120mm x 120mm x 25mm fan with a 4-pin header. It is not suited for builds that require 3-pin voltage control only, smaller frame sizes, or thicker bay depths.

4-pin PWM connector decides compatibility

The 4-wire 4-pin interface is the single specification that determines whether this fan can be used. Your motherboard or fan controller must provide a matching 4-pin PWM header for full speed regulation.

Βασικά χαρακτηριστικά

120 mm frame fits standard case mounts
25 mm depth suits typical clearance
PWM 4-pin header enables speed control
12 V 0.75 A rating delivers reliable airflow
Foxconn build quality supports continuous operation

Προδιαγραφές

Type	Case Fan

Ερωτήσεις για αυτό το προϊόν

How do I connect the 4-pin PWM connector to my motherboard and which orientation mistake should I avoid?

Align the keyed notch on the 4-pin plug with the tab on the motherboard header and press straight down; forcing it backwards bends the pins and disables speed control.

What part of the fan will wear out first and when should I plan to replace it?

The sleeve bearing inside the motor is the wear item; expect replacement when noise rises or RPM drops below the rated speed.

At what power draw does the fan hit its thermal limit during continuous operation?

The 12 V, 0.75 A rating sets the ceiling; sustained loads at that draw will eventually trigger the motor’s over-temperature protection.

Επίσης σε αυτό το ράφι