Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse

Computer Memory Solutions

Computer Memory Solutions CM5126410600DIMM 4GB DDR3 1333MHz for HP 6000 Pro SFF Microtower memory upgrade

SKU CH-CER3-3Z95D

4GB DDR3 1333MHz DIMM module for HP 6000 Pro SFF and Microtower desktops

  • Capacity4GB
  • Type240-Pin DDR3 SDRAM
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL9
  • Timing9-9-9
  • Voltage1.5V
  • 4GB DDR3 1333MHz boosts HP 6000 Pro responsiveness
  • Non-ECC unbuffered 240-pin DIMM installs in seconds
  • Guaranteed compatibility with SFF and Microtower 6000 Pro
  • 5V CL9 timing matches factory specifications
  • Lifetime warranty from Computer Memory Solutions

HP 6000 Pro Desktop Memory

This 4 GB DDR3 module is built for HP Compaq Business Desktop 6000 Pro SFF and Microtower systems. It installs as a single 240-pin DIMM to add capacity to compatible workstations.

DDR3-1333 Bus Limit

The system memory bus runs at 1066 MHz even with 1333 MHz modules installed, so the higher-rated speed will not be reached. Maximum supported memory is 16 GB across four slots, and a 64-bit operating system is required to address the full amount.

Upgrade From Smaller Kits

Replacing 1 GB or 2 GB sticks with this 4 GB module increases total memory toward the 16 GB ceiling. The jump is worthwhile when the current configuration leaves less than 3.5 GB usable or when dual-channel pairs can be completed for balanced bandwidth.

Põhijooned

  • 4GB DDR3 1333MHz boosts HP 6000 Pro responsiveness
  • Non-ECC unbuffered 240-pin DIMM installs in seconds
  • Guaranteed compatibility with SFF and Microtower 6000 Pro
  • 5V CL9 timing matches factory specifications
  • Lifetime warranty from Computer Memory Solutions

Tehnilised andmed

BrandComputer Memory Solutions
ModelCM5126410600DIMM
Capacity4GB
Type240-Pin DDR3 SDRAM
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL9
Timing9-9-9
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemHp Business Desktop 6000 Pro (Sff) (Microtower)
Package Content1 Memory RAM Stick

Küsimused selle toote kohta

Should I buy a single 4 GB module or fill all four slots for the 16 GB maximum?

The HP 6000 Pro has four DIMM sockets and supports up to 16 GB total; you can add modules one at a time, but they must be installed in matched pairs to enable dual-channel operation.

The module is rated at 1333 MHz — will it actually run at that speed in the 6000 Pro?

HP documentation states the memory bus runs at 1066 MHz, so a 1333 MHz DIMM will operate at the lower 1066 MHz bus speed once installed.

Does the 240-pin DDR3 DIMM fit the 6000 Pro SFF and Microtower without issues?

Yes — the module is a 240-pin DDR3 SDRAM DIMM specified for both the HP 6000 Pro SFF and Microtower form factors.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.