Computer Memory Solutions
Computer Memory Solutions CM5126410600DIMM 4GB DDR3 1333MHz for HP 6000 Pro SFF Microtower memory upgrade
4GB DDR3 1333MHz DIMM module for HP 6000 Pro SFF and Microtower desktops
- Capacity4GB
- Type240-Pin DDR3 SDRAM
- SpeedDDR3 1333 (PC3 10600)
- CAS LatencyCL9
- Timing9-9-9
- Voltage1.5V
- 4GB DDR3 1333MHz boosts HP 6000 Pro responsiveness
- Non-ECC unbuffered 240-pin DIMM installs in seconds
- Guaranteed compatibility with SFF and Microtower 6000 Pro
- 5V CL9 timing matches factory specifications
- Lifetime warranty from Computer Memory Solutions
HP 6000 Pro Desktop Memory
This 4 GB DDR3 module is built for HP Compaq Business Desktop 6000 Pro SFF and Microtower systems. It installs as a single 240-pin DIMM to add capacity to compatible workstations.
DDR3-1333 Bus Limit
The system memory bus runs at 1066 MHz even with 1333 MHz modules installed, so the higher-rated speed will not be reached. Maximum supported memory is 16 GB across four slots, and a 64-bit operating system is required to address the full amount.
Upgrade From Smaller Kits
Replacing 1 GB or 2 GB sticks with this 4 GB module increases total memory toward the 16 GB ceiling. The jump is worthwhile when the current configuration leaves less than 3.5 GB usable or when dual-channel pairs can be completed for balanced bandwidth.
Privalumai
- 4GB DDR3 1333MHz boosts HP 6000 Pro responsiveness
- Non-ECC unbuffered 240-pin DIMM installs in seconds
- Guaranteed compatibility with SFF and Microtower 6000 Pro
- 5V CL9 timing matches factory specifications
- Lifetime warranty from Computer Memory Solutions
Specifikacijos
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM5126410600DIMM |
| Capacity | 4GB |
| Type | 240-Pin DDR3 SDRAM |
| Speed | DDR3 1333 (PC3 10600) |
| CAS Latency | CL9 |
| Timing | 9-9-9 |
| Voltage | 1.5V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Hp Business Desktop 6000 Pro (Sff) (Microtower) |
| Package Content | 1 Memory RAM Stick |
Klausimai apie šią prekę
Should I buy a single 4 GB module or fill all four slots for the 16 GB maximum?
The HP 6000 Pro has four DIMM sockets and supports up to 16 GB total; you can add modules one at a time, but they must be installed in matched pairs to enable dual-channel operation.
The module is rated at 1333 MHz — will it actually run at that speed in the 6000 Pro?
HP documentation states the memory bus runs at 1066 MHz, so a 1333 MHz DIMM will operate at the lower 1066 MHz bus speed once installed.
Does the 240-pin DDR3 DIMM fit the 6000 Pro SFF and Microtower without issues?
Yes — the module is a 240-pin DDR3 SDRAM DIMM specified for both the HP 6000 Pro SFF and Microtower form factors.
Taip pat šiame skyriuje
Kiti pirkėjai taip pat lygino
Ta pati lentyna, tas pats atsiskaitymas — aštuonios monetos ir 30 minučių fiksuotas kursas.



