Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Standard 3.5 inch silver SAS hard drive with green circuit board visible

DELL

DELL ST3000NM0023 3 TB 7.2K RPM 3.5" SAS internal hard drive

SKU CH-KSQN-BMZSP MPN ST3000NM0023

3 TB SAS hard drive spins at 7.2K RPM in a 3.5 inch form factor

  • 3 TB capacity stores large data sets
  • 2K RPM spindle speed delivers consistent throughput
  • SAS interface connects to enterprise controllers
  • 5-inch form factor fits standard drive bays

Dell 3 TB SAS hard drive

The Dell ST3000NM0023 is a 3.5 inch internal hard drive with a 3 TB capacity and a 7.2K RPM spindle speed. It connects through a SAS interface and is supplied in new condition. The unit carries Dell part number 055H49 and manufacturer model ST3000NM0023.

Suited for SAS storage arrays

This drive fits servers and storage enclosures that accept 3.5 inch SAS drives and need 3 TB of capacity at 7.2K RPM. Buyers who require a different interface, a smaller form factor, or higher rotational speed should look at other models.

Põhijooned

  • 3 TB capacity stores large data sets
  • 2K RPM spindle speed delivers consistent throughput
  • SAS interface connects to enterprise controllers
  • 5-inch form factor fits standard drive bays

Tehnilised andmed

Selle toote kohta ei ole veel tehnilisi andmeid avaldatud.

Küsimused selle toote kohta

Will this 3.5" SAS drive fit a standard 3.5" drive bay in my Dell server?

Yes, the 3.5 inch form factor matches a standard 3.5 inch drive bay; the SAS interface uses the same physical connector spacing as other enterprise 3.5 inch SAS drives.

What is the correct way to install this SAS drive so the system recognises it?

Insert the drive into a hot-swap tray or caddy, seat it firmly until the SAS connector engages fully, then secure the tray latch; the common mistake is leaving the tray latch unlatched, which breaks the SAS connection.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.