Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.

Spremljani izdelki Prijava
Standard 3.5 inch silver SAS hard drive with green circuit board visible

DELL

DELL ST3000NM0023 3 TB 7.2K RPM 3.5" SAS internal hard drive

SKU CH-KSQN-BMZSP MPN ST3000NM0023

3 TB SAS hard drive spins at 7.2K RPM in a 3.5 inch form factor

  • 3 TB capacity stores large data sets
  • 2K RPM spindle speed delivers consistent throughput
  • SAS interface connects to enterprise controllers
  • 5-inch form factor fits standard drive bays

Dell 3 TB SAS hard drive

The Dell ST3000NM0023 is a 3.5 inch internal hard drive with a 3 TB capacity and a 7.2K RPM spindle speed. It connects through a SAS interface and is supplied in new condition. The unit carries Dell part number 055H49 and manufacturer model ST3000NM0023.

Suited for SAS storage arrays

This drive fits servers and storage enclosures that accept 3.5 inch SAS drives and need 3 TB of capacity at 7.2K RPM. Buyers who require a different interface, a smaller form factor, or higher rotational speed should look at other models.

Poudarki

  • 3 TB capacity stores large data sets
  • 2K RPM spindle speed delivers consistent throughput
  • SAS interface connects to enterprise controllers
  • 5-inch form factor fits standard drive bays

Specifikacije

Za ta izdelek še ni objavljenih specifikacij.

Vprašanja o tem izdelku

Will this 3.5" SAS drive fit a standard 3.5" drive bay in my Dell server?

Yes, the 3.5 inch form factor matches a standard 3.5 inch drive bay; the SAS interface uses the same physical connector spacing as other enterprise 3.5 inch SAS drives.

What is the correct way to install this SAS drive so the system recognises it?

Insert the drive into a hot-swap tray or caddy, seat it firmly until the SAS connector engages fully, then secure the tray latch; the common mistake is leaving the tray latch unlatched, which breaks the SAS connection.

Tudi v tem oddelku

Stranke so primerjale tudi te

Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.