Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Standard 3.5 inch silver SAS hard drive with green circuit board visible

DELL

DELL ST3000NM0023 3 TB 7.2K RPM 3.5" SAS internal hard drive

SKU CH-KSQN-BMZSP MPN ST3000NM0023

3 TB SAS hard drive spins at 7.2K RPM in a 3.5 inch form factor

  • 3 TB capacity stores large data sets
  • 2K RPM spindle speed delivers consistent throughput
  • SAS interface connects to enterprise controllers
  • 5-inch form factor fits standard drive bays

Dell 3 TB SAS hard drive

The Dell ST3000NM0023 is a 3.5 inch internal hard drive with a 3 TB capacity and a 7.2K RPM spindle speed. It connects through a SAS interface and is supplied in new condition. The unit carries Dell part number 055H49 and manufacturer model ST3000NM0023.

Suited for SAS storage arrays

This drive fits servers and storage enclosures that accept 3.5 inch SAS drives and need 3 TB of capacity at 7.2K RPM. Buyers who require a different interface, a smaller form factor, or higher rotational speed should look at other models.

Helstu kostir

  • 3 TB capacity stores large data sets
  • 2K RPM spindle speed delivers consistent throughput
  • SAS interface connects to enterprise controllers
  • 5-inch form factor fits standard drive bays

Tæknilýsing

Engin birt tæknilýsing fyrir þessa vöru enn.

Spurningar um þessa vöru

Will this 3.5" SAS drive fit a standard 3.5" drive bay in my Dell server?

Yes, the 3.5 inch form factor matches a standard 3.5 inch drive bay; the SAS interface uses the same physical connector spacing as other enterprise 3.5 inch SAS drives.

What is the correct way to install this SAS drive so the system recognises it?

Insert the drive into a hot-swap tray or caddy, seat it firmly until the SAS connector engages fully, then secure the tray latch; the common mistake is leaving the tray latch unlatched, which breaks the SAS connection.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.