Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.

Overvåkingsliste Logg inn
Standard 3.5 inch silver SAS hard drive with green circuit board visible

DELL

DELL ST3000NM0023 3 TB 7.2K RPM 3.5" SAS internal hard drive

SKU CH-KSQN-BMZSP MPN ST3000NM0023

3 TB SAS hard drive spins at 7.2K RPM in a 3.5 inch form factor

  • 3 TB capacity stores large data sets
  • 2K RPM spindle speed delivers consistent throughput
  • SAS interface connects to enterprise controllers
  • 5-inch form factor fits standard drive bays

Dell 3 TB SAS hard drive

The Dell ST3000NM0023 is a 3.5 inch internal hard drive with a 3 TB capacity and a 7.2K RPM spindle speed. It connects through a SAS interface and is supplied in new condition. The unit carries Dell part number 055H49 and manufacturer model ST3000NM0023.

Suited for SAS storage arrays

This drive fits servers and storage enclosures that accept 3.5 inch SAS drives and need 3 TB of capacity at 7.2K RPM. Buyers who require a different interface, a smaller form factor, or higher rotational speed should look at other models.

Høydepunkter

  • 3 TB capacity stores large data sets
  • 2K RPM spindle speed delivers consistent throughput
  • SAS interface connects to enterprise controllers
  • 5-inch form factor fits standard drive bays

Spesifikasjoner

Ingen publiserte spesifikasjoner for denne varen ennå.

Spørsmål om denne varen

Will this 3.5" SAS drive fit a standard 3.5" drive bay in my Dell server?

Yes, the 3.5 inch form factor matches a standard 3.5 inch drive bay; the SAS interface uses the same physical connector spacing as other enterprise 3.5 inch SAS drives.

What is the correct way to install this SAS drive so the system recognises it?

Insert the drive into a hot-swap tray or caddy, seat it firmly until the SAS connector engages fully, then secure the tray latch; the common mistake is leaving the tray latch unlatched, which breaks the SAS connection.

Også i denne avdelingen

Kunder sammenlignet disse

Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.