SanDisk
SanDisk Cruzer Blade 8 GB USB 2.0 USB flash drive Black SDCZ50-008G-B35
391,99 $
0.00501099BTC
Laos
LORDWORLD
LORDWORLD Ethernet USB HUB HAT B 1x RJ45 3x USB 2.0 development board
Adds one RJ45 Ethernet port and three USB 2.0 ports to Raspberry Pi Zero and larger models using pogo pins or a USB cable
- Adds wired networking with 10/100M auto-negotiation via RTL8152B chip
- Expands connectivity using three USB 2.0 ports compatible with 1.1 devices
- Attaches directly to Pi Zero boards through pogo pin interface
- Connects to Pi 4B, 3B+, 3A+ or 2B via USB HUB cable
- Plug-and-play design requires no driver installation for immediate use
Product identity
The LORDWORLD Ethernet USB HUB HAT B adds one RJ45 port and three USB 2.0 ports to Raspberry Pi boards. It uses an RTL8152B chip for 10/100M auto-negotiation and connects either through pogo pins on Zero models or a USB cable on larger Pi boards.
Target users and limits
Makers who need wired networking and extra USB ports on a Pi Zero, 3A+, 3B+, 2B or 4B will find this convenient. Builders who require gigabit Ethernet, USB 3.0 speeds or Power-over-Ethernet should look elsewhere because the hardware does not support those standards.
Installation notes
The pogo pin header aligns directly with the Zero GPIO for a solderless fit, while other Pi models use the supplied USB link cable. No drivers are needed on standard Raspberry Pi OS. Misaligned pogo pins are the most common issue; press the HAT firmly and evenly to ensure all contacts engage.
Põhijooned
- Adds wired networking with 10/100M auto-negotiation via RTL8152B chip
- Expands connectivity using three USB 2.0 ports compatible with 1.1 devices
- Attaches directly to Pi Zero boards through pogo pin interface
- Connects to Pi 4B, 3B+, 3A+ or 2B via USB HUB cable
- Plug-and-play design requires no driver installation for immediate use
Tehnilised andmed
| Brand | LORDWORLD |
|---|
Küsimused selle toote kohta
Which Raspberry Pi models can I connect directly with the pogo pins?
The pogo pin design connects directly to Raspberry Pi Zero, Zero W, and Zero WH boards.
Can I use this HAT with a Raspberry Pi 4B without the pogo pins?
Yes, the USB HUB connector links to Raspberry Pi 4B, 3B+, 3A+, and 2B through a USB cable.
How do I verify the Ethernet link is running at 100 Mbit/s after setup?
Check the connection status on the Pi; the RTL8152B chip auto-negotiates 10/100M and will show 100 Mbps when the link is at full speed.
Veel samast osakonnast
Kliendid võrdlesid neid ka
Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.
