We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green circuit board with RJ45 port and three USB sockets, pogo pins along one edge

LORDWORLD

LORDWORLD Ethernet USB HUB HAT B 1x RJ45 3x USB 2.0 development board

SKU CH-8QPG-R28YN

Adds one RJ45 Ethernet port and three USB 2.0 ports to Raspberry Pi Zero and larger models using pogo pins or a USB cable

  • Adds wired networking with 10/100M auto-negotiation via RTL8152B chip
  • Expands connectivity using three USB 2.0 ports compatible with 1.1 devices
  • Attaches directly to Pi Zero boards through pogo pin interface
  • Connects to Pi 4B, 3B+, 3A+ or 2B via USB HUB cable
  • Plug-and-play design requires no driver installation for immediate use

Product identity

The LORDWORLD Ethernet USB HUB HAT B adds one RJ45 port and three USB 2.0 ports to Raspberry Pi boards. It uses an RTL8152B chip for 10/100M auto-negotiation and connects either through pogo pins on Zero models or a USB cable on larger Pi boards.

Target users and limits

Makers who need wired networking and extra USB ports on a Pi Zero, 3A+, 3B+, 2B or 4B will find this convenient. Builders who require gigabit Ethernet, USB 3.0 speeds or Power-over-Ethernet should look elsewhere because the hardware does not support those standards.

Installation notes

The pogo pin header aligns directly with the Zero GPIO for a solderless fit, while other Pi models use the supplied USB link cable. No drivers are needed on standard Raspberry Pi OS. Misaligned pogo pins are the most common issue; press the HAT firmly and evenly to ensure all contacts engage.

Highlights

  • Adds wired networking with 10/100M auto-negotiation via RTL8152B chip
  • Expands connectivity using three USB 2.0 ports compatible with 1.1 devices
  • Attaches directly to Pi Zero boards through pogo pin interface
  • Connects to Pi 4B, 3B+, 3A+ or 2B via USB HUB cable
  • Plug-and-play design requires no driver installation for immediate use

Specifications

BrandLORDWORLD

Questions about this item

Which Raspberry Pi models can I connect directly with the pogo pins?

The pogo pin design connects directly to Raspberry Pi Zero, Zero W, and Zero WH boards.

Can I use this HAT with a Raspberry Pi 4B without the pogo pins?

Yes, the USB HUB connector links to Raspberry Pi 4B, 3B+, 3A+, and 2B through a USB cable.

How do I verify the Ethernet link is running at 100 Mbit/s after setup?

Check the connection status on the Pi; the RTL8152B chip auto-negotiates 10/100M and will show 100 Mbps when the link is at full speed.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.