Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two green DDR3L 240-pin ECC RDIMM modules, 16GB kit

A-Tech

A-Tech 16GB (2x8GB) DDR3L 1333 ECC RDIMM 2Rx4 1.35V 240-Pin Server RAM Kit

SKU CH-XBFC-VXXFM

A 16 GB dual-channel DDR3L 1333 ECC registered DIMM kit for compatible servers and workstations

  • Capacity16GB (2 x 8GB)
  • SpeedDDR3L 1333 (PC3L 10600)
  • CAS LatencyCL9
  • Voltage1.35V
  • ECCYes
  • Buffered/RegisteredRegistered

Capacity 16GB (2 x 8GB)

Speed DDR3L 1333 (PC3L 10600)

  • 16 GB dual-channel kit expands server memory capacity
  • 2 x 8 GB DDR3L 1333 MHz modules deliver balanced throughput
  • ECC registered RDIMM detects and corrects single-bit errors
  • 2Rx4 dual-rank x4 organisation optimises density per channel
  • 35 V low-voltage operation reduces power draw

Server ECC RDIMM kit

This 16 GB kit contains two 8 GB DDR3L registered DIMMs built for servers and workstations that require ECC memory. Each module runs at 1333 MHz with CL9 latency and a 2Rx4 organisation. The kit is not compatible with standard desktop or laptop platforms.

Low-voltage registered operation

Modules operate at 1.35 V and can also run at 1.5 V, reducing power draw and heat in dense memory configurations. Registered buffering lightens the electrical load on the memory controller, helping stability in multi-DIMM layouts. ECC circuitry corrects single-bit errors to protect data integrity.

240-pin dual-channel upgrade

The 240-pin DIMMs install in matched pairs to populate dual-channel slots on qualified server boards. Major-brand chips and full validation testing aim to deliver reliable operation under sustained workloads. Verify your system manual for supported speeds, maximum capacity and population rules before installation.

Kohokohdat

  • 16 GB dual-channel kit expands server memory capacity
  • 2 x 8 GB DDR3L 1333 MHz modules deliver balanced throughput
  • ECC registered RDIMM detects and corrects single-bit errors
  • 2Rx4 dual-rank x4 organisation optimises density per channel
  • 35 V low-voltage operation reduces power draw

Tekniset tiedot

BrandA-Tech
SeriesA-Tech DDR3 Server Memory RAM
ModelA-Tech 8GB 2Rx4 PC3L-10600R
Capacity16GB (2 x 8GB)
SpeedDDR3L 1333 (PC3L 10600)
CAS LatencyCL9
Voltage1.35V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
Multi-channel KitDual Channel Kit
ChipsetMajor Brand Chipset
FeaturesMajor Brand Chips

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

How do I install these 240-pin DDR3L RDIMMs in a dual-channel server, and what step is often missed?

Power down, open the chassis, align each module's notch with the slot key, press firmly until both latches click, then populate the correct channel pair indicated in the system manual for dual-channel operation.

What maintenance or replacement will this 16GB ECC registered kit need over time?

No routine maintenance is required; the modules either pass POST or they do not, so replacement only occurs if a stick fails or a capacity upgrade is desired.

What limit appears first when this 1333 MHz CL9 registered memory runs sustained workloads?

The 1333 MHz bus speed and CL9 latency set the throughput ceiling, so bandwidth saturates before the 1.35 V low-voltage headroom becomes a factor.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.