Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green circuit board with black memory chips, no heat spreader, 288-pin DDR4 DIMM

A-Tech

A-Tech 16GB DDR4 2933MHz CL21 1.2V Desktop RAM

SKU CH-CP26-KPXGH

16GB DDR4 2933MHz CL21 1.2V desktop memory module for Kingston KVR29N21S8/16 compatibility

  • Capacity16GB
  • SpeedDDR4 2933 (PC4 23400)
  • Tested Frequency2933
  • CAS LatencyCL21
  • Voltage1.20V
  • ECCNo
  • 16GB DDR4 module expands multitasking headroom for demanding workloads
  • 2933MHz rated speed accelerates data throughput across the memory bus
  • CL21 latency timing keeps response tight under load
  • 2V standard voltage minimises power draw and heat output
  • 288-pin DIMM form factor fits mainstream desktop motherboards

16 GB DDR4 desktop module

This 16 GB DDR4 DIMM runs at 2933 MHz with CL21 latency and 1.20 V. It is an unbuffered, non-ECC stick built as a direct replacement for the Kingston KVR29N21S8/16 part. The 288-pin form factor fits standard desktop memory slots.

Suits owners of systems that specify DDR4 2933

Buyers needing ECC, registered, low-profile or higher-frequency memory should select a different module. The single 16 GB rank works in boards that accept 1Rx8 density at this speed and voltage. Compatibility must be confirmed against the motherboard manual.

Deciding spec: 2933 MHz CL21 at 1.20 V

If the platform requires exactly this data rate and timing the module will operate at rated settings without manual adjustment. A different speed or latency grade will cause the board to down-clock or fail to post. Match the frequency and CAS figures before purchase.

Kohokohdat

  • 16GB DDR4 module expands multitasking headroom for demanding workloads
  • 2933MHz rated speed accelerates data throughput across the memory bus
  • CL21 latency timing keeps response tight under load
  • 2V standard voltage minimises power draw and heat output
  • 288-pin DIMM form factor fits mainstream desktop motherboards

Tekniset tiedot

BrandA-Tech
SeriesCompatible Replacement for Kingston
ModelKVR29N21S8/16
Capacity16GB
SpeedDDR4 2933 (PC4 23400)
Tested Frequency2933
CAS LatencyCL21
Voltage1.20V
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor Brand Chipset
Heat SpreaderNo
FeaturesKVR29N21S8/16
Recommend UseCompatible Replacement for Kingston KVR29N21S8/16

Kysymyksiä tästä tuotteesta

Will this 288-pin DDR4 DIMM fit my desktop motherboard?

The module uses the standard 288-pin DDR4 DIMM form factor, so it fits any desktop board with a DDR4 slot.

What is the correct way to seat this module, and what step do people often miss?

Align the notch with the slot key, press down firmly until both side clips click shut, then verify the system reports 2933 MHz in BIOS.

Does this 1.2 V DDR4 module need any maintenance or replacement over time?

No ongoing maintenance is required; the module is tested for lifetime reliability and carries a lifetime warranty.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.