Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green rectangular circuit board with black memory chips and gold edge connectors

A-Tech

A-Tech 24GB DDR5-4800 ECC RDIMM Server RAM

SKU CH-4SN3-2JKBA

24 GB DDR5-4800 ECC registered DIMM for server and workstation upgrades

  • Capacity24GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS Latency40
  • Voltage1.10V
  • ECCYes
  • 24 GB capacity supports larger server workloads
  • DDR5 4800 MT/s transfers data at high bandwidth
  • ECC RDIMM corrects errors for data integrity
  • Registered design reduces electrical load on the memory controller
  • 1 V operation meets DDR5 standard voltage

24GB DDR5-4800 ECC RDIMM Server Module

This 24GB registered DIMM uses DDR5 technology at 4800 speed with ECC and a CAS latency of 40. It is built for servers and workstations that require error-correcting registered memory. The module operates at the standard 1.1V voltage and uses a 288-pin form factor with a 1Rx8 rank configuration.

Replaces Hynix HMCGJ8MEBRB Modules

This module serves as a compatible replacement for Hynix part numbers HMCGJ8MEBRB and HMCGJ8MEBRB216N. The upgrade is worth it when a system needs additional registered ECC capacity or when an existing DIMM has failed. It matches the original PC5-38400 specification so the memory controller sees identical timing and voltage parameters.

Simple DIMM Slot Installation

Installation follows standard server DIMM procedures: power down, open the chassis, align the 288-pin edge connector with the keyed slot, and press firmly until the retention clips lock. Common issues include mixing registered and unbuffered DIMMs in the same channel, populating slots in the wrong sequence for the platform, or failing to seat the module fully which causes boot errors.

Kohokohdat

  • 24 GB capacity supports larger server workloads
  • DDR5 4800 MT/s transfers data at high bandwidth
  • ECC RDIMM corrects errors for data integrity
  • Registered design reduces electrical load on the memory controller
  • 1 V operation meets DDR5 standard voltage

Tekniset tiedot

BrandA-Tech
SeriesCompatible Replacement for Hynix HMCGJ8MEBRB HMCGJ8MEBRB216N
ModelA-Tech 24GB DDR5-4800 ECC RDIMM Server RAM Module
Capacity24GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS Latency40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
FeaturesMajor Brand DRAM IC Chips

Kysymyksiä tästä tuotteesta

Will the 288-pin DDR5 RDIMM fit my server motherboard slot?

This module uses the standard 288-pin DDR5 RDIMM form factor. It fits any server or workstation board with DDR5 RDIMM slots. Verify your platform supports DDR5 registered memory before purchase.

What is the correct way to seat this 1Rx8 registered module and which mistake should I avoid?

Align the notch on the module with the slot key, press straight down until both side clips click. The common error is inserting it at an angle or stopping before the clips lock fully.

Does the 24GB ECC RDIMM need any firmware updates or periodic replacement?

No firmware updates are required for the memory itself. ECC corrects single-bit errors on the fly. Replace the module only if system diagnostics report persistent correctable or uncorrectable errors.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.