Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green rectangular DDR5 DIMM with black chips and gold edge connectors

A-Tech

A-Tech 32GB DDR5 4800 ECC RDIMM 1Rx4 HMCG84MEBQA113N

SKU CH-F6S9-CM8TN

32 GB DDR5 4800 ECC registered DIMM with CL40 latency and 1.10 V operation

  • Capacity32GB
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes
  • Buffered/RegisteredRegistered
  • 32GB capacity expands server memory for heavier workloads
  • DDR5 4800 speed delivers high bandwidth for data-intensive tasks
  • ECC registered design corrects errors to protect data integrity
  • 10V operation reduces power draw in dense configurations
  • 1Rx4 organisation optimises signal integrity on 288-pin DIMM

32GB DDR5 4800 ECC RDIMM

This 32GB DDR5 module runs at 4800MHz with CL40 latency and 1.10V operation. It uses a 288-pin DIMM form factor and features ECC registered (RDIMM) architecture with a 1Rx4 (EC4) rank configuration. The module is built as a compatible replacement for Hynix HMCG84MEBQA, HMCG84MEBQA113N, and HMCG84MEBQA115N part numbers.

Server and workstation memory upgrades

Suited for administrators expanding capacity in DDR5 server or workstation platforms that require registered ECC memory. Not suitable for desktop boards that accept only unbuffered non-ECC DIMMs, nor for systems limited to lower memory speeds or voltages. Buyers who need a different capacity, rank layout, or CAS latency should verify platform requirements before ordering.

1Rx4 registered ECC rank layout

The single-rank 1Rx4 (EC4) organisation determines how the memory controller addresses this module and influences maximum supported capacity per channel. Confirm that the target platform supports this specific rank configuration and registered ECC operation to ensure compatibility.

Kohokohdat

  • 32GB capacity expands server memory for heavier workloads
  • DDR5 4800 speed delivers high bandwidth for data-intensive tasks
  • ECC registered design corrects errors to protect data integrity
  • 10V operation reduces power draw in dense configurations
  • 1Rx4 organisation optimises signal integrity on 288-pin DIMM

Tekniset tiedot

BrandA-Tech
SeriesCompatible Replacement for Hynix
ModelHMCG84MEBQA, HMCG84MEBQA113N, HMCG84MEBQA115N
Capacity32GB
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx4 (EC4)
ChipsetMajor Brand Chipset
FeaturesHMCG84MEBQA, HMCG84MEBQA113N, HMCG84MEBQA115N

Kysymyksiä tästä tuotteesta

Will this 288-pin DDR5 DIMM fit my server's registered memory slots?

The module uses the standard 288-pin DDR5 DIMM form factor and is a registered ECC RDIMM, so it fits server and workstation boards that accept DDR5 RDIMMs.

Do I need to change any BIOS settings when installing this 1Rx4 CL40 module?

Install the DIMM with the system powered off, seat it until the retention clips click, then enable ECC in the BIOS if it is not on by default; the module runs at 1.1 V and CL40 at 4800 MT/s.

How do I know when this 32 GB ECC RDIMM should be replaced?

ECC corrects single-bit errors and logs them; replace the module if the system reports uncorrectable errors, repeated correctable-error thresholds are crossed, or memory diagnostics show persistent failures.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.