Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Six green DDR4 RDIMM modules in a row

A-Tech

A-Tech 48GB (6x8GB) DDR4 2133MHz ECC RDIMM 1Rx4 CL15 1.20V memory upgrade

SKU CH-5ETN-FP95V

A 48GB kit of six 8GB DDR4 2133MHz ECC registered DIMMs for Dell PowerEdge 13th Gen rack servers

  • Capacity48GB (6 x 8GB)
  • Type288-Pin DDR4 SDRAM
  • SpeedDDR4 2133 (PC4 17000)
  • CAS LatencyCL15
  • Voltage1.20V
  • ECCYes

Capacity 48GB (6 x 8GB)

Näytä 4 muuta kokoonpanoa

Speed DDR4 2133 (PC4 17000)

  • ECC registered design protects data integrity in Dell PowerEdge 13th Gen servers
  • 48GB kit with six 8GB modules expands memory capacity for virtualisation workloads
  • DDR4 2133MHz CL15 timing delivers stable throughput at 1.20V
  • 288-pin RDIMM form factor fits R430 R530 R630 R630 XL R730 R730 XL R730xd R730xd XL R830 R930
  • Single rank 1Rx4 organisation enables flexible channel population across supported platforms

48GB DDR4 ECC RDIMM kit for 13th Gen Dell PowerEdge

This 48GB kit contains six 8GB DDR4 2133MHz ECC registered DIMMs built for Dell PowerEdge 13th generation rack servers. It targets administrators expanding memory in R430, R530, R630, R730, R730xd, R830 or R930 platforms. The modules run at 1.20V with CL15 latency and a 1Rx4 organisation.

Verify registered ECC support

Your server must accept DDR4 ECC registered DIMMs; unbuffered or non-ECC modules will not work. Check the system manual for the correct slot population order and maximum capacity per channel. Mixing registered and load-reduced DIMMs is not supported, and the system will clock all modules to the slowest installed speed.

288-pin modules without heat spreaders for dense

Each stick uses a standard 288-pin DDR4 form factor and has no heat spreader, allowing tight side-by-side installation in crowded rack chassis. The registered buffer reduces electrical load on the memory controller, helping stability when all slots are populated. Handle by the edges to avoid contaminating the gold contacts.

Kohokohdat

  • ECC registered design protects data integrity in Dell PowerEdge 13th Gen servers
  • 48GB kit with six 8GB modules expands memory capacity for virtualisation workloads
  • DDR4 2133MHz CL15 timing delivers stable throughput at 1.20V
  • 288-pin RDIMM form factor fits R430 R530 R630 R630 XL R730 R730 XL R730xd R730xd XL R830 R930
  • Single rank 1Rx4 organisation enables flexible channel population across supported platforms

Tekniset tiedot

BrandA-Tech
Series13th Gen Dell PowerEdge Rack Server Compatible
Model48GB (6x8GB) 1Rx4 DDR4-2133 RDIMM for Dell PowerEdge R430, R530, R630, R630 XL, R730, R730 XL, R730xd, R730xd XL, R830, R930
Part NumberNE-MS-0058
Capacity48GB (6 x 8GB)
Type288-Pin DDR4 SDRAM
SpeedDDR4 2133 (PC4 17000)
CAS LatencyCL15
Voltage1.20V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx4
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemDell PowerEdge R430, R530, R630, R630 XL, R730, R730 XL, R730xd, R730xd XL, R830, R930 | 13th Gen Rack Servers
OptionCompatible with Dell PowerEdge R430, R530, R630, R630 XL, R730, R730 XL, R730xd, R730xd XL, R830, R930
FeaturesDesigned for Dell PowerEdge R430, R530, R630, R630 XL, R730, R730 XL, R730xd, R730xd XL, R830, R930
Package ContentSix Modules

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Does the 48GB kit ship as six 8GB modules or do I need to buy anything else?

The kit includes six 8GB RDIMM modules, giving 48GB total with no extra parts required.

Should I choose the 1Rx4 registered ECC version or a different rank or voltage for my Dell PowerEdge R730?

This kit is 1Rx4 registered ECC at 1.20V, matching the R730 specification; other ranks or unbuffered types are not compatible.

What does the 2133MHz rating mean once the memory is installed in a PowerEdge R630?

The modules run at DDR4 2133MHz CL15; if mixed with slower DIMMs the system will operate at the lowest speed present.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.