Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green rectangular DDR3 240-pin server memory module with black chips and gold contacts

A-Tech

A-Tech 4GB DDR3 1333 ECC RDIMM 2Rx8 Server RAM

SKU CH-CY3M-C3EPZ

4GB DDR3 1333 ECC registered server memory module with 2Rx8 organisation, 1.5V operation and 240-pin DIMM form factor

  • Capacity4GB
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL9
  • Voltage1.50V
  • ECCYes
  • Buffered/RegisteredRegistered
  • ECC protection guards data integrity in critical workloads
  • Registered design stabilises signal quality on heavily loaded buses
  • 1333 MHz DDR3 speed matches PC3-10600 system requirements
  • 5 V standard voltage fits existing DDR3 platforms
  • 240-pin DIMM form factor installs directly into server slots

Server Memory Upgrade

This 4 GB DDR3 1333 MHz registered ECC module is built for server and workstation boards that require registered DIMMs. It replaces Samsung M393B5273BH1-CH9, M393B5273CH0-CH9, M393B5273DH0-CH9 and M393B5273EB0-CH9 parts. Buyers needing unbuffered UDIMMs or higher-density kits cannot use this module.

Thermals and Power

The stick runs at the standard DDR3 voltage of 1.5 V with CL9 latency, keeping power draw low inside a 240-pin DIMM slot. Passive cooling is sufficient for normal server workloads because registered buffering reduces electrical load on the memory controller. No active fan or heatsink is required for typical operation.

Compatibility Assurance

Each unit is tested against major-brand chipsets to verify reliable POST and sustained throughput in qualified platforms. The lifetime warranty and US-based technical support provide direct assistance if a compatibility issue arises during installation. Systems that do not support registered ECC memory will not accept this module.

Kohokohdat

  • ECC protection guards data integrity in critical workloads
  • Registered design stabilises signal quality on heavily loaded buses
  • 1333 MHz DDR3 speed matches PC3-10600 system requirements
  • 5 V standard voltage fits existing DDR3 platforms
  • 240-pin DIMM form factor installs directly into server slots

Tekniset tiedot

BrandA-Tech
Capacity4GB
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL9
Voltage1.50V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor Brand Chipset
FeaturesMajor Brand Chips

Kysymyksiä tästä tuotteesta

How do I install this 240-pin DDR3 ECC RDIMM, and what step is often missed?

Power off the server, open the chassis, align the notch on the module with the slot key, press firmly until both locking tabs click, then verify in BIOS that the 4GB module is recognised at 1333 MHz with ECC active.

What maintenance or replacement will this registered DIMM need over time?

No scheduled maintenance is required; keep the server's air filters clean so the 1.5 V modules stay cool, and replace the DIMM only if memory diagnostics report correctable or uncorrectable ECC errors.

What limit appears first when this 2Rx8 module runs under sustained load?

The memory controller's maximum supported capacity per channel or total system limit will be reached before the 1333 MHz CL9 rated speed becomes a bottleneck.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.