Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green 204-pin DDR3 SODIMM circuit board with black memory chips, no heat spreader

A-Tech

A-Tech 4GB DDR3 1333MHz PC3-10600 SODIMM 2Rx8 laptop RAM

SKU CH-XG4G-P6WHQ

4GB DDR3 1333MHz SODIMM laptop memory module with CL9 timing and 1.5V operation

  • Capacity4GB
  • Type204-Pin DDR3 SO-DIMM
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL9
  • Voltage1.50V
  • ECCNo
  • 4GB capacity lets you run more apps at once
  • 1333MHz DDR3 speed matches PC3-10600 standard
  • 204-pin SO-DIMM fits laptop memory slots
  • 5V operation meets DDR3 voltage spec
  • Tested for reliable performance in HP VH001AV systems

4GB DDR3 1333MHz SODIMM for HP VH001AV

This A-Tech module provides 4GB of DDR3 memory running at 1333MHz with a PC3-10600 rating. It uses a 204-pin SO-DIMM form factor and operates at the standard 1.5V voltage. The kit is a compatible replacement for the HP VH001AV part number and is designed for laptop, notebook, and all-in-one computers.

Suits owners of compatible HP systems needing

This single-rank 2Rx8 module is unbuffered and non-ECC with a CL9 latency profile. It is intended for systems that specifically accept DDR3 SO-DIMM memory at this voltage and pin count. Builders requiring ECC error correction, registered buffering, higher capacities, or a different memory generation should look at other options.

Voltage fixed at 1.5V DDR3 standard

The module runs at 1.50V with no support for lower-voltage operation. Verify that your laptop or all-in-one motherboard specifies 1.5V DDR3 SO-DIMM compatibility before purchase, as systems requiring a different voltage will not work with this part.

Kohokohdat

  • 4GB capacity lets you run more apps at once
  • 1333MHz DDR3 speed matches PC3-10600 standard
  • 204-pin SO-DIMM fits laptop memory slots
  • 5V operation meets DDR3 voltage spec
  • Tested for reliable performance in HP VH001AV systems

Tekniset tiedot

BrandA-Tech
SeriesCompatible Replacement for HP
ModelVH001AV
Capacity4GB
Type204-Pin DDR3 SO-DIMM
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL9
Voltage1.50V
ECCNo
Buffered/RegisteredUnbuffered
Heat SpreaderNo
FeaturesVH001AV
Recommend UseCompatible Replacement for HP VH001AV

Kysymyksiä tästä tuotteesta

How do I install this 204-pin DDR3 SODIMM and what step do people often miss?

Power off the laptop, unplug it, and remove the battery if possible. Open the memory compartment, align the notch on the 204-pin module with the slot key, insert at an angle, then press down firmly until both side clips click. The step often missed is pressing down hard enough to fully seat the module and engage both clips.

What maintenance or replacement will this 4GB DDR3 module need later?

No routine maintenance is required for this unbuffered non-ECC SODIMM. It has no heat spreader, so keep the laptop vents clear of dust to avoid overheating. Replacement is only needed if the module fails or if you upgrade to a higher-capacity DDR3 kit supported by your system.

What limit appears first on this 1.5V CL9 DDR3 1333MHz module under sustained use?

The primary limit is the 4GB capacity, which can bottleneck multitasking and cause swapping before the 1333MHz speed or CL9 latency become constraints. Thermal throttling is unlikely at standard 1.5V operation without a heat spreader, provided the laptop cooling works correctly.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.