Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green rectangular 240-pin DDR3L server memory module with black chips and gold contacts

A-Tech

A-Tech 4GB DDR3L 1333 ECC RDIMM 2Rx8 1.35V for Kingston KVR1333D3LD8R9S/4G Server Memory

SKU CH-QAW7-648W3

4 GB DDR3L 1333 MHz ECC registered DIMM for server and workstation upgrades

  • Capacity4GB
  • SpeedDDR3L 1333 (PC3L 10600)
  • CAS LatencyCL9
  • Voltage1.35V
  • ECCYes
  • Buffered/RegisteredRegistered
  • 4GB DDR3L 1333MHz expands server capacity
  • ECC RDIMM protects data integrity in critical workloads
  • 35V low voltage reduces power consumption
  • 240-pin registered DIMM fits compatible server slots
  • CL9 latency supports responsive system performance

Server DDR3L module for registered memory slots

This 4 GB DDR3L 1333 ECC RDIMM is built for servers and workstations that require registered, error-correcting memory. It runs at 1.35 V low voltage and fits 240-pin DIMM sockets. The module is a compatible replacement for the Kingston KVR1333D3LD8R9S/4G part number.

Low-voltage registered design limits heat and power

Operating at 1.35 V reduces power draw compared to standard 1.5 V DDR3, which helps keep system thermals lower in densely populated memory configurations. Registered buffering adds a clock cycle but lightens the electrical load on the memory controller, contributing to stable operation under sustained workloads.

Major-brand chips tested for ECC reliability

The module uses major-brand DRAM chips and undergoes quality-assurance testing to verify ECC function and registered signalling. This validation aims to deliver dependable error correction and signal integrity for mission-critical server deployments.

Kohokohdat

  • 4GB DDR3L 1333MHz expands server capacity
  • ECC RDIMM protects data integrity in critical workloads
  • 35V low voltage reduces power consumption
  • 240-pin registered DIMM fits compatible server slots
  • CL9 latency supports responsive system performance

Tekniset tiedot

BrandA-Tech
Capacity4GB
SpeedDDR3L 1333 (PC3L 10600)
CAS LatencyCL9
Voltage1.35V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor Brand Chipset
FeaturesMajor Brand Chips

Kysymyksiä tästä tuotteesta

How do I install this 240-pin DDR3L RDIMM and what step is often missed?

Power off the server, open the chassis, align the notch on the 240-pin module with the slot key, press firmly until both retention clips click, then verify in BIOS that the 1.35V voltage and ECC registered mode are recognised.

What maintenance or replacement will this 4GB DDR3L 1333 module need over time?

No routine maintenance is required; if a memory error appears, reseat the module or replace the single 4GB stick — there are no batteries, fans or firmware to service.

What limit appears first when this CL9 1.35V RDIMM runs sustained workloads?

The 1333 MT/s data rate and CL9 latency set the throughput ceiling; sustained heavy loads will hit that bandwidth limit before the 1.35V thermal envelope becomes a constraint.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.