Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green 240-pin DDR3L registered DIMM with black chips and gold contacts

A-Tech

A-Tech 4GB DDR3L 1600MHz ECC RDIMM 2Rx8 Server RAM

SKU CH-CTQY-801VJ

4GB DDR3L 1600MHz ECC registered DIMM with 2Rx8 organisation, CL11 latency and 1.35V operation

  • Capacity4GB
  • SpeedDDR3L 1600 (PC3L 12800)
  • CAS LatencyCL11
  • Voltage1.35V
  • ECCYes
  • Buffered/RegisteredRegistered
  • ECC protection prevents data corruption in critical workloads
  • Registered design improves signal integrity for stable server operation
  • DDR3L 1.35V voltage reduces power draw and heat output
  • 2Rx8 dual-rank organisation increases memory density per slot
  • 240-pin DIMM form factor fits compatible Dell A6994474 systems

4GB DDR3L ECC Registered DIMM

This 4GB DDR3L module runs at 1600MHz with CL11 latency and 1.35V low voltage. It is built as a registered ECC DIMM using a 2Rx8 configuration with major brand chips. The 240-pin form factor fits server and workstation boards that require registered memory. It serves as a direct replacement for Dell part A6994474.

Steady throughput under continuous load

Registered buffering reduces electrical load on the memory controller, allowing stable operation during sustained workloads. ECC circuitry detects and corrects single-bit errors in real time, preventing data corruption during long compute tasks. The low-voltage DDR3L design limits heat output while maintaining the rated 1600MHz speed over extended periods.

240-pin registered build for dense servers

The 240-pin DIMM uses a registered interface that supports higher module counts per channel than unbuffered alternatives. Major brand chips are tested to stringent quality standards for dependable daily operation. Low-voltage 1.35V operation eases power budget constraints in multi-DIMM configurations. Buyers needing unbuffered UDIMMs or higher capacities per module should verify platform requirements before ordering.

Kohokohdat

  • ECC protection prevents data corruption in critical workloads
  • Registered design improves signal integrity for stable server operation
  • DDR3L 1.35V voltage reduces power draw and heat output
  • 2Rx8 dual-rank organisation increases memory density per slot
  • 240-pin DIMM form factor fits compatible Dell A6994474 systems

Tekniset tiedot

BrandA-Tech
Capacity4GB
SpeedDDR3L 1600 (PC3L 12800)
CAS LatencyCL11
Voltage1.35V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor Brand Chipset
FeaturesMajor Brand Chips

Kysymyksiä tästä tuotteesta

How much power does the 1.35V DDR3L module draw when the server runs continuously?

Operating at 1.35V, this DDR3L RDIMM consumes less power than standard 1.5V DDR3, reducing heat output during 24/7 server workloads.

What motherboard slot and chipset support are required to use this 240-pin ECC RDIMM?

You need a server or workstation motherboard with a 240-pin DDR3 DIMM slot that supports registered ECC memory and 1.35V DDR3L operation.

Will this CL11 1600MHz registered module work alongside older CL9 DDR3 DIMMs already installed?

Mixing registered ECC with unbuffered non-ECC DIMMs is not supported; all slots must use registered ECC modules of matching voltage and rank configuration.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.