Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green rectangular DDR4 server memory module with gold contacts and black chips on both sides

A-Tech

A-Tech 64GB DDR4 2933MHz ECC RDIMM CL21 2Rx4 Server Memory

SKU CH-QZKQ-ACEYW

64GB DDR4 2933MHz ECC registered DIMM with CL21 latency for server workloads

  • Capacity64GB
  • SpeedDDR4 2933 (PC4 23400)
  • CAS LatencyCL21
  • Voltage1.20V
  • ECCYes
  • Buffered/RegisteredRegistered
  • 64 GB capacity expands server multitasking headroom
  • DDR4 2933 MHz speed accelerates data throughput
  • ECC registered design protects critical workloads
  • CL21 latency at 1.2 V balances response and efficiency
  • 2Rx4 288-pin layout fits compatible DDR4 slots

64GB DDR4 2933MHz ECC RDIMM

This 64GB DDR4 2933MHz ECC RDIMM module is built for server and workstation systems that require registered, error-correcting memory. It operates at 1.2V with a CL21 latency and uses a 2Rx4 rank configuration. The module is a compatible replacement for the Kingston KTD-PE429/64G part.

DDR4 288-Pin DIMM interface limits

The DDR4 288-pin DIMM interface supports this module at 2933MHz (PC4-23400) with a standard 1.2V voltage. Registered DIMMs add a clock cycle for buffering, which stabilises heavy loads but prevents use in platforms that accept only unbuffered UDIMMs. Maximum capacity and speed depend on the specific motherboard and processor memory controller.

Installation and common issues

Install by aligning the 288-pin module with the DDR4 DIMM slot and pressing firmly until the retention clips lock. Common issues include mixing registered and unbuffered DIMMs, populating slots in an order the firmware does not support, or exceeding the platform's maximum rank count per channel. Verify the system's qualified vendor list before installation.

Kohokohdat

  • 64 GB capacity expands server multitasking headroom
  • DDR4 2933 MHz speed accelerates data throughput
  • ECC registered design protects critical workloads
  • CL21 latency at 1.2 V balances response and efficiency
  • 2Rx4 288-pin layout fits compatible DDR4 slots

Tekniset tiedot

BrandA-Tech
SeriesCompatible Replacement for Kingston
ModelKTD-PE429/64G
Capacity64GB
SpeedDDR4 2933 (PC4 23400)
CAS LatencyCL21
Voltage1.20V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor Brand Chipset
FeaturesKTD-PE429/64G

Kysymyksiä tästä tuotteesta

Should I pick the 64GB DDR4 2933MHz ECC RDIMM or a different capacity for my server?

This listing is a single 64GB module. Choose it when your system needs one 64GB registered DIMM at 2933MHz with ECC. If your board requires a different total capacity, add or remove identical modules to match the supported configuration.

What does the 2933MHz rating deliver once the module is installed?

The module runs at DDR4 2933MHz (PC4-23400) with CL21 latency and 1.20V. In a compatible server or workstation it provides 64GB of registered ECC memory at that rated speed and timing.

Does the DDR4 288-pin RDIMM interface limit the usable speed or capacity?

The 288-pin DDR4 RDIMM form factor carries the 2933MHz signal and 64GB capacity. Actual operating speed is capped by the platform memory controller and the maximum frequency it supports for registered ECC DIMMs.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.