Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

A-Tech

A-Tech 8GB (2x4GB) DDR3L 1333 ECC UDIMM 2Rx8 1.35V Server RAM

SKU CH-22PX-D75X5

Dual-channel 8 GB DDR3L ECC UDIMM kit with two 4 GB modules at 1333 MHz CL9, 1.35 V, 240-pin, dual-rank x8 for servers and workstations

  • Capacity8GB (2 x 4GB)
  • SpeedDDR3L 1333 (PC3L 10600)
  • CAS LatencyCL9
  • Voltage1.35V
  • ECCYes
  • Buffered/RegisteredUnbuffered

Capacity 8GB (2 x 4GB)

Speed DDR3L 1333 (PC3L 10600)

  • 8GB dual-channel kit doubles bandwidth for server workloads
  • DDR3L 1333 MHz speed accelerates data throughput
  • ECC unbuffered design detects and corrects memory errors
  • 35 V low-voltage operation reduces power draw
  • 240-pin UDIMM form factor fits compatible server slots

8GB DDR3L ECC UDIMM Kit

This A-Tech kit supplies 8 GB of DDR3L memory as two 4 GB modules rated at 1333 MHz with CL9 latency. It is built for servers and workstations that require ECC unbuffered DIMMs operating at 1.35 V. The dual-rank x8 organisation supports dual-channel configurations on compatible platforms.

Compatibility Check Before Ordering

Verify that your system expressly supports DDR3 or DDR3L ECC unbuffered UDIMMs in a 240-pin form factor. Desktop and laptop platforms are not compatible with this memory type. Consult the motherboard or server manual for approved memory population rules and maximum supported capacity per slot.

Sustained-Load Behaviour

Under continuous workloads the modules maintain their rated 1333 MHz speed and 1.35 V operating point while ECC corrects single-bit errors in real time. The low-voltage design reduces thermal output during extended operation compared to standard 1.5 V DDR3. All chips are tested for stability across prolonged duty cycles.

Kohokohdat

  • 8GB dual-channel kit doubles bandwidth for server workloads
  • DDR3L 1333 MHz speed accelerates data throughput
  • ECC unbuffered design detects and corrects memory errors
  • 35 V low-voltage operation reduces power draw
  • 240-pin UDIMM form factor fits compatible server slots

Tekniset tiedot

BrandA-Tech
SeriesA-Tech DDR3 Server Memory RAM
ModelA-Tech 4GB 2Rx8 PC3L-10600E
Capacity8GB (2 x 4GB)
SpeedDDR3L 1333 (PC3L 10600)
CAS LatencyCL9
Voltage1.35V
ECCYes
Buffered/RegisteredUnbuffered
Rank2Rx8
Multi-channel KitDual Channel Kit
ChipsetMajor Brand Chipset
FeaturesMajor Brand Chips

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Does the kit include only the two 4 GB modules or are any brackets or cables supplied?

The kit contains two 4 GB DDR3L 1333 ECC UDIMM modules and nothing else; no brackets, cables or additional hardware are included.

Should I choose this dual-rank 2Rx8 kit or look for a single-rank alternative for my server?

This kit uses dual-rank 2Rx8 organisation; choose it if your server or workstation requires dual-rank ECC unbuffered DIMMs, otherwise select a single-rank kit that matches your platform's qualified vendor list.

Will the 1333 MHz rating run at that speed once installed in my system?

The modules are rated for 1333 MHz at CL9 and 1.35 V; actual operating speed is set by the server's memory controller and BIOS, so it will run at the highest common speed supported by the platform.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.