Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green 288-pin DDR4 ECC RDIMM module with black chips

A-Tech

A-Tech 8GB DDR4 2133MHz ECC RDIMM 1Rx4 Server RAM

SKU CH-CHQV-RBSF5

8GB DDR4 2133MHz ECC registered server memory with CL15 latency and 1.20V operation

  • Capacity8GB
  • SpeedDDR4 2133 (PC4 17000)
  • CAS LatencyCL15
  • Voltage1.20V
  • ECCYes
  • Buffered/RegisteredRegistered
  • ECC protection prevents data corruption in server workloads
  • Registered design with 1Rx4 organisation stabilises signal integrity
  • DDR4 2133 MHz CL15 timing delivers reliable throughput
  • 20 V standard voltage reduces power draw per module
  • 288-pin DIMM form factor fits compatible server platforms

Server-grade DDR4 ECC RDIMM

This 8GB DDR4 2133MHz module delivers registered ECC memory for servers and workstations that require error correction and signal buffering. The 1Rx4 organisation with CL15 timing operates at the standard 1.20V DDR4 voltage. Major-brand chips are used throughout and every unit is tested before shipment.

Thermals noise and power draw

Registered DIMMs run at the standard DDR4 voltage of 1.20V, keeping power draw low inside dense server chassis. The module produces no audible noise because it has no moving parts. Heat output is modest and handled by normal chassis airflow without additional cooling.

Build fit and system impact

The 288-pin DIMM fits DDR4 RDIMM slots in compatible server and workstation boards. ECC and registered signalling reduce electrical load on the memory controller, freeing headroom for larger memory populations. Buyers who need non-ECC unbuffered memory or higher frequencies should verify platform requirements before ordering.

Kohokohdat

  • ECC protection prevents data corruption in server workloads
  • Registered design with 1Rx4 organisation stabilises signal integrity
  • DDR4 2133 MHz CL15 timing delivers reliable throughput
  • 20 V standard voltage reduces power draw per module
  • 288-pin DIMM form factor fits compatible server platforms

Tekniset tiedot

BrandA-Tech
Capacity8GB
SpeedDDR4 2133 (PC4 17000)
CAS LatencyCL15
Voltage1.20V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx4
ChipsetMajor Brand Chipset
FeaturesMajor Brand Chips

Kysymyksiä tästä tuotteesta

How do I install this 288-pin DDR4 ECC RDIMM and which step is often missed?

Power down the server, open the chassis, align the module notch with the slot key, press firmly until both retention clips click, then verify in BIOS that ECC is enabled — many forget to enable ECC after physical installation.

What maintenance or replacement will this registered DIMM need over its service life?

No scheduled maintenance is required; the module either continues operating or fails, at which point it is replaced as a single 8 GB unit — there are no user-serviceable components on the DIMM itself.

What limit appears first when this CL15 1.20 V module runs sustained workloads?

The memory controller's maximum supported capacity per channel or total system DIMM slots will be reached before the module's own speed or voltage ratings become a bottleneck.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.