Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two green DDR3 ECC UDIMM sticks, 240-pin, silver contacts

A-Tech

A-Tech 8GB Kit (2x4GB) DDR3 1066 ECC UDIMM 240-Pin Memory Upgrade

SKU CH-1KX2-2RVFM

ECC UDIMM kit adds 8 GB DDR3 1066 memory to compatible Mac Pro and Xserve models

  • Capacity8GB (2 x 4GB)
  • SpeedDDR3 1066 (PC3 8500)
  • Voltage1.50V
  • ECCYes
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor Brand Chipset
  • 8GB kit expands Mac Pro multitasking capacity
  • DDR3 1066 ECC UDIMM protects data integrity
  • 240-pin unbuffered modules install directly in supported slots
  • Compatible with Mac Pro Early 2009 through Mid 2012
  • Major-brand chips tested for reliable operation

Targeted Mac Pro and Xserve Memory Upgrade

This 8 GB kit contains two 4 GB DDR3 1066 ECC UDIMM modules built for specific Apple Mac Pro towers from Early 2009 through Mid 2012 and Early 2009 Xserve units. It matches the PC3-8500 specification and uses unbuffered ECC chips on a 240-pin form factor. The modules are designed for systems identified by model IDs MacPro4,1, MacPro5,1 and Xserve3,1.

Sustained Workload Stability

ECC circuitry detects and corrects single-bit errors during continuous operation, helping prevent data corruption in long rendering, virtualization or server tasks. The 1.50 V modules run at the native 1066 MHz bus speed without overclocking, so thermal output remains consistent with the original system design. Unbuffered layout keeps latency low for the memory controller in these Xeon-based platforms.

Direct Slot Installation

Modules insert vertically into the 240-pin DDR3 slots on the Mac Pro or Xserve memory risers; no tools or firmware updates are required. The kit is validated for the listed Apple order numbers and model numbers, so mismatched rank or voltage issues are avoided. Buyers needing larger capacities or registered DIMM support for other Mac models cannot use this kit.

Kohokohdat

  • 8GB kit expands Mac Pro multitasking capacity
  • DDR3 1066 ECC UDIMM protects data integrity
  • 240-pin unbuffered modules install directly in supported slots
  • Compatible with Mac Pro Early 2009 through Mid 2012
  • Major-brand chips tested for reliable operation

Tekniset tiedot

BrandA-Tech
SeriesA-Tech DDR3 Apple Mac RAM Memory Upgrades
Capacity8GB (2 x 4GB)
SpeedDDR3 1066 (PC3 8500)
Voltage1.50V
ECCYes
Buffered/RegisteredUnbuffered
ChipsetMajor Brand Chipset
Compatible SystemApple Mac Systems
FeaturesMajor Brand Chips

Kysymyksiä tästä tuotteesta

How much heat does the 1.50 V DDR3 1066 ECC kit add when the Mac Pro runs all day?

The modules run at standard 1.50 V DDR3 voltage, so they add only the normal heat expected from two 4 GB unbuffered ECC DIMMs under continuous load.

What must the Mac Pro already have for this 240-pin DDR3 1066 ECC UDIMM kit to work?

The Mac Pro must be one of the listed Early 2009, Mid 2010 or Mid 2012 models with Xeon processors such as the 2.26 GHz E5520 or 2.93 GHz X5570 and have free 240-pin DDR3 ECC UDIMM slots.

Will this DDR3 1066 ECC kit run at the correct speed alongside the original 1066 MHz memory in a 2009 Mac Pro?

Yes, the kit matches the PC3-8500 1066/1067 MHz spec of the factory memory, so all installed DIMMs will operate at the same 1066 MHz speed.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.