NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
Brute Networks
Registered ECC DDR4 server memory with 64 GB capacity, 2666 MHz speed, 2Rx4 organisation and 1.2 V operation
This 64GB DDR4-2666 registered ECC module is built for HPE servers that require PC4-21300 memory. It targets administrators expanding capacity in supported ProLiant or Apollo platforms. The 2Rx4 organisation and 1.20V operation match the original specification. Buyers needing unbuffered DIMMs or consumer speeds cannot use this part.
Installation follows the standard 288-pin DDR4 slot procedure: align the key notch, press until the ejector tabs lock, and verify seating. Registered modules add a slight delay during POST while the memory controller trains the buffer. The most common issue is mixing ranks or speeds across channels, which can prevent boot or force the system to run at the lowest common rate.
A single 64GB stick provides substantial headroom for virtualisation hosts, in-memory databases or large container fleets. Populating all slots with matching modules maximises total capacity within the platform limit. Workloads that exceed the per-socket memory ceiling or require faster than 2666 MT/s transfer rates will need a different platform generation.
| Brand | HPE |
|---|---|
| Capacity | 64GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2666 (PC4 21300) |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
Check the BIOS or UEFI memory information screen; it should report 2666 MT/s and 1.20V for each installed module.
The kit contains the 288-pin DDR4 registered ECC module only; no extra cables, brackets or software are required for installation.
Select this 64GB 2Rx4 module when your server requires a registered ECC DIMM at 2666 MT/s and you need maximum density per slot.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?