NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
Brute Networks
8GB DDR4-3200 registered ECC server memory, HPE P07638-K21 compatible with major-brand chips
This 8GB DDR4-3200 registered ECC module is built for HPE servers that require PC4-25600 memory. It uses a 1Rx8 organisation and runs at 1.20 V across 288 pins. The part is validated for 100 percent compatibility with the P07638-K21 specification.
The registered 1Rx8 design places a register between the DRAM and the memory controller to reduce electrical load per channel. This allows the server to populate more slots per channel while maintaining signal integrity at the rated 3200 MT/s data rate.
Error correction runs on every transaction without adding latency stalls during continuous workloads. The major-brand DRAM and 1.20 V operation keep power draw stable, so throughput remains consistent across extended compute jobs rather than only in short bursts.
| Brand | HPE |
|---|---|
| Capacity | 8GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 3200 (PC4 25600) |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 1Rx8 |
| Chipset | Major Brand Chipset |
The module is rated for DDR4-3200 (PC4-25600) at 1.20 V. Actual operating speed depends on the server's memory controller and populated DIMM slots; HPE platforms typically clock to the highest common speed supported by the CPU and configuration.
Yes. The 288-pin DDR4 RDIMM form factor with 1Rx8 organisation and on-board ECC matches the mechanical and electrical requirements of HPE Gen9 and Gen10 server memory slots that accept registered ECC modules.
Standard 288-pin DDR4 RDIMM height applies; no oversized heatsink is present. Ensure the server's DIMM ejector arms can fully close and that airflow paths are not blocked by adjacent components or cable routing.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?