Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two green DDR1 DIMMs with gold contacts and black chips

Computer Memory Solutions

Computer Memory Solutions 4GB (2x2GB) DDR1 266MHz ECC Registered DIMM - B57

SKU CH-NPQP-BPGRY

DDR1 registered ECC memory kit supplying 4 GB across two 2 GB DIMMs for HP ProLiant ML360 G3 servers

  • Capacity4GB (2 x 2GB)
  • Type184-Pin DDR SDRAM
  • SpeedDDR 266 (PC 2100)
  • CAS LatencyCL2
  • Timing2-2-2
  • Voltage2.5V
  • ECC registered design protects server data integrity
  • DDR1 266MHz CL2 timing matches original ProLiant spec
  • 184-pin DIMM form factor fits ML360 G3 slots
  • 4GB kit (2×2GB) uses major-brand chipset
  • Guaranteed compatible with HP part 300682-B21

Server DDR1 ECC Registered Kit

This 4 GB kit contains two 2 GB registered DIMMs built for DDR1 266 MHz operation. ECC and registered buffering provide the error correction and signal stability required by the supported server platforms. The modules use 184-pin connectors and run at 2.5 V with CL2 2-2-2 timing.

HP ProLiant ML360 G3 and blade compatibility

The kit is validated for HP ProLiant ML360 G3, ML370 G3, ML380 G3, DL585 and several Integrity and ProLiant blade models. Systems that require unbuffered non-ECC memory or a different DDR generation will not accept these modules. Buyers needing higher capacity per slot or faster DDR speeds should look elsewhere.

Sustained load behaviour

Registered signalling and ECC checking maintain data integrity during continuous server workloads. The CL2 timing and 2.5 V operation keep latency low while the registered design reduces electrical load on the memory bus over long periods. No heat spreader is fitted, so adequate chassis airflow is necessary for stable temperatures.

Kohokohdat

  • ECC registered design protects server data integrity
  • DDR1 266MHz CL2 timing matches original ProLiant spec
  • 184-pin DIMM form factor fits ML360 G3 slots
  • 4GB kit (2×2GB) uses major-brand chipset
  • Guaranteed compatible with HP part 300682-B21

Tekniset tiedot

BrandComputer Memory Solutions
ModelCM256722100ECCREGDIMMCL2
Capacity4GB (2 x 2GB)
Type184-Pin DDR SDRAM
SpeedDDR 266 (PC 2100)
CAS LatencyCL2
Timing2-2-2
Voltage2.5V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemHp/Compaq Proliant Ml360 G3
Package Content2 Memory RAM Sticks

Kysymyksiä tästä tuotteesta

What server models must I own to use this 184-Pin DDR1 266MHz ECC Registered DIMM kit?

This kit is validated for HP/Compaq ProLiant ML360 G3, ML370 G3, ML380 G3, ML150, DL585 (DDR-266MHz), BL20p G2, BL30p, BL40p and Integrity BL60p Blade systems.

Can I mix these CL2 Registered modules with older unbuffered DDR1 DIMMs already in my ProLiant?

No, Registered and unbuffered DIMMs cannot be mixed on the same memory bus; the server requires all slots to use Registered modules of matching speed and voltage.

How do I confirm the kit is running at the rated 266MHz CL2 after installation?

Enter the server BIOS or run a memory diagnostic utility; it should report each module as PC2100 DDR 266 with 2-2-2 timings at 2.5V.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.