Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two green DDR2 DIMM sticks, 240-pin, no heat spreaders

Computer Memory Solutions

Computer Memory Solutions 4GB (2x2GB) DDR2 800MHz CL6 1.8V 240-Pin DIMM Kit

SKU CH-T9RE-GB3RP

A 4GB dual-channel DDR2 kit running at 800MHz with CL6 timings for Intel DG43GT, DG45FC, DP965LT and DG33BU motherboards

  • Capacity4GB (2 x 2GB)
  • Type240-Pin DDR2 SDRAM
  • SpeedDDR2 800 (PC2 6400)
  • CAS LatencyCL6
  • Timing6-6-6
  • Voltage1.8V
  • 4GB kit expands capacity for older Intel boards
  • DDR2-800 CL6 timing keeps legacy systems stable
  • 8 V operation matches original motherboard spec
  • Two unbuffered 240-pin DIMMs install in matched pairs
  • Backed by CMS limited lifetime warranty

Targeted DDR2 kit for legacy Intel boards

This Computer Memory Solutions kit delivers 4 GB across two 2 GB DDR2 800 modules rated at CL6 1.8 V. The 240-pin unbuffered non-ECC DIMMs are validated for Intel DG43GT, DG45FC, DP965LT and DG33BU motherboards. Builders restoring or upgrading those specific platforms can install the pair with confidence.

Not for ECC, registered or higher-density needs

Systems that require error-correcting code, registered modules or individual sticks larger than 2 GB will not accept this kit. Buyers needing more than 4 GB total capacity must look elsewhere because the validated boards top out at 8 GB across four slots.

DDR2 800 CL6 1.8 V 240-pin specification

The decisive figure is the DDR2 800 (PC2-6400) speed with CL6 timing at 1.8 V on a 240-pin unbuffered DIMM. Only motherboards that explicitly support this exact combination will post reliably with these modules.

Kohokohdat

  • 4GB kit expands capacity for older Intel boards
  • DDR2-800 CL6 timing keeps legacy systems stable
  • 8 V operation matches original motherboard spec
  • Two unbuffered 240-pin DIMMs install in matched pairs
  • Backed by CMS limited lifetime warranty

Tekniset tiedot

BrandComputer Memory Solutions
ModelCM256646400DIMMDR
Capacity4GB (2 x 2GB)
Type240-Pin DDR2 SDRAM
SpeedDDR2 800 (PC2 6400)
CAS LatencyCL6
Timing6-6-6
Voltage1.8V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemIntel Dg43Gt, Dg45Fc, Dp965Lt, Dg33Bu Motherboard
Package Content2 Memory RAM Sticks

Kysymyksiä tästä tuotteesta

How much heat or power does the 1.8 V DDR2 kit draw when the system runs continuously?

Each module operates at 1.8 V and is unbuffered, so typical power draw stays low during all-day use; the kit has no heat spreader, relying on normal case airflow.

What motherboard slot and chipset must I already have for these 240-pin DIMMs to work?

You need a board with four 240-pin DDR2 slots and one of the listed Intel chipsets — DG43GT, DG45FC, DP965LT or DG33BU — that supports up to 8 GB total.

Will the CL6 800 MHz sticks run stably alongside older CL5 DDR2 modules I keep installed?

The motherboard will clock all modules to the slowest common speed and latency; mixing CL6 with tighter-timed sticks usually works but may require manual BIOS timing adjustments.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.