Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two green 240-pin DDR2 FB-DIMM modules with black chips

Computer Memory Solutions

Computer Memory Solutions 8GB (2x4GB) DDR2 667MHz PC2-5300 ECC Fully Buffered DIMM memory upgrade

SKU CH-AB87-SC0D3

DDR2 667MHz ECC fully buffered DIMM kit adds 8GB to compatible Supermicro X7DVL server motherboards

  • Capacity8GB (2 x 4GB)
  • Type240-Pin DDR2 SDRAM
  • SpeedDDR2 667 (PC2 5300)
  • CAS LatencyCL5
  • Timing5-5-5
  • Voltage1.8V
  • ECC protection prevents data corruption on servers
  • Fully buffered design supports heavy multi-module loads
  • 667 MHz DDR2 speed matches board specs
  • 8 GB kit fills two slots on Supermicro X7DVL
  • 8 V operation keeps power draw low

8 GB DDR2 ECC kit for Supermicro servers

This 8 GB kit contains two 4 GB DDR2 667 MHz fully buffered DIMMs with ECC and a CAS latency of CL5. It is built for the Supermicro X7DVL-3, X7DVL-E and X7DVL-i motherboards and runs at 1.8 V. The modules use a 240-pin form factor and a 2Rx4 rank configuration.

Suits maintainers of legacy Supermicro platforms.

The memory is validated only for the three listed Supermicro server boards, which accept up to 16 GB across six sockets. Systems that require unbuffered DIMMs, a different pin count, a higher DDR2 speed grade or a non-ECC configuration cannot use this kit.

Fully buffered DDR2 667 MHz with ECC decides fit

The motherboard must support fully buffered DDR2 667 MHz ECC DIMMs on a 240-pin interface; any other memory standard or buffering scheme will be physically or electrically incompatible.

Kohokohdat

  • ECC protection prevents data corruption on servers
  • Fully buffered design supports heavy multi-module loads
  • 667 MHz DDR2 speed matches board specs
  • 8 GB kit fills two slots on Supermicro X7DVL
  • 8 V operation keeps power draw low

Tekniset tiedot

BrandComputer Memory Solutions
ModelCM512725300FBDIMM
Capacity8GB (2 x 4GB)
Type240-Pin DDR2 SDRAM
SpeedDDR2 667 (PC2 5300)
CAS LatencyCL5
Timing5-5-5
Voltage1.8V
ECCYes
Buffered/RegisteredFully Buffered
Rank2Rx4
ChipsetMajor Brand Chipset
Heat SpreaderBased on Current Inventory (If Required Please Contact)
Compatible SystemSupermicro X7Dvl-3, X7Dvl-E, X7Dvl-I Motherboard
Package Content2 Memory RAM Sticks

Kysymyksiä tästä tuotteesta

Will the fully buffered DIMM design require any special maintenance or replacement over time?

Fully buffered DIMMs contain an advanced memory buffer chip that handles signal integrity; no user-serviceable parts exist, so the modules themselves need no maintenance beyond keeping the server chassis clean.

What limit appears first when these 4 GB modules run sustained workloads on the X7DVL boards?

The six-slot, three-bank layout caps total capacity at 16 GB, so the channel population limit is reached before any thermal or bandwidth ceiling.

How much power and heat do the 1.8 V DDR2-667 modules add when the server runs all day?

Each stick draws 1.8 V at DDR2-667 speeds; fully buffered operation adds modest buffer-chip dissipation, but total draw stays within standard FB-DIMM thermal envelopes for 240-pin slots.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.