Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two green DDR3 SO-DIMM sticks with black chips, no heat spreader

Computer Memory Solutions

Computer Memory Solutions 8GB (2x4GB) DDR3 1066 CL7 MacBook 13" Unibody 2.4

SKU CH-1EQQ-VDW08

An 8 GB DDR3 SO-DIMM kit for 13-inch Unibody MacBook Core 2 Duo 2.4 models

  • Capacity8GB (2 x 4GB)
  • Type204-Pin DDR3 SO-DIMM
  • SpeedDDR3 1066 (PC3 8500)
  • CAS LatencyCL7
  • Timing7-7-7
  • Voltage1.5V
  • 8GB kit doubles capacity for late-2008 MacBook 13
  • DDR3 1066 CL7 timing matches factory spec exactly
  • 204-pin SO-DIMM form factor fits the Unibody slot
  • 5 V unbuffered modules run without extra cooling
  • Matched 2×4 GB pair enables dual-channel bandwidth

MacBook 13" Unibody Memory Upgrade

This 8 GB kit contains two 4 GB DDR3 SO-DIMM modules built specifically for the Apple MacBook "Core 2 Duo" 2.4 13" Unibody from late 2008. It targets owners of that model who need the maximum 8 GB capacity the two slots allow. Builders working on any other platform cannot use this memory.

Thermals Noise and Power Draw

Unbuffered DDR3 modules without heat spreaders run at the standard 1.5 V and produce minimal heat inside the tight Unibody chassis. The memory adds no audible noise because it has no moving parts. Power draw remains within the original system specification for SODIMM slots.

CL7 Timing at 1066 MHz

Rated at DDR3 1066 (PC3 8500) with CAS latency CL7 and 7-7-7 timing, these sticks match the factory memory speed the MacBook requires. Faster or slower modules would not keep the system stable. The CL7 figure is the single specification that decides whether this kit works correctly in the target notebook.

Kohokohdat

  • 8GB kit doubles capacity for late-2008 MacBook 13
  • DDR3 1066 CL7 timing matches factory spec exactly
  • 204-pin SO-DIMM form factor fits the Unibody slot
  • 5 V unbuffered modules run without extra cooling
  • Matched 2×4 GB pair enables dual-channel bandwidth

Tekniset tiedot

BrandComputer Memory Solutions
ModelCM512648500SODRH
Capacity8GB (2 x 4GB)
Type204-Pin DDR3 SO-DIMM
SpeedDDR3 1066 (PC3 8500)
CAS LatencyCL7
Timing7-7-7
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemApple Macbook "Core 2 Duo" 2.4 13" (Unibody)
Package Content2 Memory RAM Sticks

Kysymyksiä tästä tuotteesta

How do I install the 204-pin DDR3 SO-DIMM modules into my MacBook 13" Unibody 2.4, and what step is often missed?

Remove the bottom case, release the retention clips on both slots, insert each 4 GB stick at an angle until the gold contacts disappear, then press down firmly until the clips snap shut; the step people skip is seating both modules completely before replacing the case.

What maintenance or replacement will this 8 GB kit need over time?

No routine maintenance is required; the unbuffered non-ECC DDR3 modules have no moving parts, so replacement is only necessary if a stick fails or you upgrade to a system that supports more memory.

What limit appears first when the memory runs at 1066 MHz under sustained load?

The CL7 7-7-7 timing at 1.5 V sets the latency floor; bandwidth is capped by the PC3-8500 rating, so throughput limits appear before thermal throttling on these heat-spreader-less modules.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.