Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green 240-pin DDR3 DIMM module, 8GB capacity

Computer Memory Solutions

Computer Memory Solutions CM10246412800DIMM 8GB DDR3 1600MHz HP/Compaq Prodesk 400 G1 SFF/MT memory upgrade

SKU CH-VZAV-1Y70P

8GB DDR3 1600MHz module upgrades HP ProDesk 400 G1 desktops with CL11 timing and 1.5V operation

  • Capacity8GB
  • Type240-Pin DDR3 SDRAM
  • SpeedDDR3 1600 (PC3 12800)
  • CAS LatencyCL11
  • Timing11-11-11
  • Voltage1.5V
  • 8GB capacity expands multitasking headroom on ProDesk 400 G1
  • 1600MHz DDR3 speed matches system bus for stable operation
  • CL11 timing delivers responsive data access at 1.5V
  • 240-pin unbuffered non-ECC design fits SFF and MT slots
  • Guaranteed compatibility with HP/Compaq ProDesk 400 G1 series

HP ProDesk 400 G1 memory upgrade

This 8 GB DDR3 module is built for HP and Compaq ProDesk 400 G1 small-form-factor and mini-tower desktops. It adds a single 240-pin DIMM to systems that currently run with less memory. The kit targets owners who want a straightforward capacity increase without changing platform.

DDR3 1600 bus limited to 1066 MHz

HP documentation states the memory bus runs at 1066 MHz even when 1333 or 1600 MHz modules are installed. The module operates at 1.5 V with CL11 timing and is non-ECC unbuffered. Dual-channel benefit requires matched pairs in both sockets. A 64-bit operating system is needed to address the full 16 GB maximum.

Single DIMM installs in one slot

The board has two sockets and modules may be added one at a time, though like pairs enable dual-channel mode. If 4 GB is already present the recognised total may drop to 3.5 GB or less depending on allocation. No heat spreader is fitted so clearance is minimal. Buyers who want more than 16 GB total cannot use this platform.

Kohokohdat

  • 8GB capacity expands multitasking headroom on ProDesk 400 G1
  • 1600MHz DDR3 speed matches system bus for stable operation
  • CL11 timing delivers responsive data access at 1.5V
  • 240-pin unbuffered non-ECC design fits SFF and MT slots
  • Guaranteed compatibility with HP/Compaq ProDesk 400 G1 series

Tekniset tiedot

BrandComputer Memory Solutions
ModelCM10246412800DIMM
Capacity8GB
Type240-Pin DDR3 SDRAM
SpeedDDR3 1600 (PC3 12800)
CAS LatencyCL11
Timing11-11-11
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemHp/Compaq Prodesk 400 G1 Series Sff/Mt
Package Content1 Memory RAM Stick

Kysymyksiä tästä tuotteesta

Should I buy the single 8 GB stick or look for a 4 GB pair for my ProDesk 400 G1?

The board has two slots and supports up to 16 GB. Installing two identical 8 GB modules enables dual-channel bandwidth, while one 8 GB stick leaves the second slot free for a matching module later.

The module is rated 1600 MHz, but HP says the bus runs at 1066 MHz — what speed will I actually see?

The system memory controller limits the data rate to 1066 MHz, so this DDR3 1600 module will operate at that lower frequency once installed.

Is this a standard 240-pin DDR3 DIMM that fits the ProDesk 400 G1 SFF and MT?

Yes, it is an unbuffered non-ECC 240-pin DDR3 DIMM specified for the HP/Compaq ProDesk 400 G1 Series SFF and MT chassis.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.