Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green circuit board memory module with black chips and gold edge contacts

Computer Memory Solutions

Computer Memory Solutions CM10246412800SODRL 8GB DDR3L 1600 CL11 1.35V SODIMM

SKU CH-8H7N-G0C4M

8GB DDR3L 1600 SODIMM module at 1.35V, CL11 timing, validated for HP ENVY m6-n010dx, m6-n113dx, m6-n168ca, m6-p114dx notebooks

  • Capacity8GB
  • Type204-Pin DDR3 SO-DIMM
  • SpeedDDR3L 1600 (PC3L 12800)
  • CAS LatencyCL11
  • Timing11-11-11
  • Voltage1.35V
  • 8GB capacity expands HP ENVY m6 notebooks to 16GB maximum
  • DDR3L 1600MHz speed matches system bus for stable performance
  • Low 1.35V voltage reduces power draw and heat output
  • CL11 timing delivers responsive multitasking for everyday workloads
  • Guaranteed compatible with HP ENVY m6-n010dx, m6-n113dx, m6-n168ca, m6-p114dx

System-specific DDR3L SODIMM for HP ENVY m6

This 8 GB module is built to match the memory slots in HP ENVY m6-n010dx, m6-n113dx, m6-n168ca and m6-p114dx notebooks. It runs at DDR3L 1600 (PC3L 12800) with CL11 timing at 1.35 V. The stick is unbuffered, non-ECC and uses a 204-pin SO-DIMM form factor. Computer Memory Solutions validates compatibility for the listed models.

Suits owners of the named ENVY m6 models adding

The kit contains a single 8 GB rank so it works when one slot is free or when replacing an existing module. It is not for systems that require ECC or registered DIMMs. It is not for laptops that only accept 1.5 V DDR3 modules. It is not for users needing a 16 GB kit in one purchase.

Voltage is the deciding specification

The module operates at 1.35 V, which is the DDR3L standard. If the target notebook requires 1.5 V DDR3, this stick may not be supported. Check the service manual or BIOS to confirm 1.35 V operation before ordering.

Kohokohdat

  • 8GB capacity expands HP ENVY m6 notebooks to 16GB maximum
  • DDR3L 1600MHz speed matches system bus for stable performance
  • Low 1.35V voltage reduces power draw and heat output
  • CL11 timing delivers responsive multitasking for everyday workloads
  • Guaranteed compatible with HP ENVY m6-n010dx, m6-n113dx, m6-n168ca, m6-p114dx

Tekniset tiedot

BrandComputer Memory Solutions
ModelCM10246412800SODRL
Capacity8GB
Type204-Pin DDR3 SO-DIMM
SpeedDDR3L 1600 (PC3L 12800)
CAS LatencyCL11
Timing11-11-11
Voltage1.35V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemHP ENVY m6-n010dx, m6-n113dx, m6-n168ca, m6-p114dx
Package Content1 Memory RAM Stick

Kysymyksiä tästä tuotteesta

Does this module need a laptop that accepts 1.35 V DDR3L SO-DIMMs?

Yes, it is a 204-pin DDR3L stick rated at 1.35 V, so the notebook must support low-voltage DDR3 memory.

Can I keep an existing 4 GB DDR3-1600 module in the second slot?

The ENVY m6 series has two sockets and a 16 GB maximum; mixing this 8 GB CL11 module with a matching-speed 4 GB stick will run both at 1600 MHz.

How do I confirm the stick is running at 1600 MHz with CL11 timings after install?

Open Task Manager or CPU-Z and check the memory tab — it should show 1600 MHz speed and 11-11-11 latency.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.