Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two green DDR4 DIMM sticks, no heat spreader, 288-pin gold contacts

Computer Memory Solutions

Computer Memory Solutions CM1024722400ECCNR 16GB (2x8GB) DDR4 2400 ECC Unregistered DIMM memory upgrade

SKU CH-2GJY-Z09X7

16 GB kit of two 8 GB DDR4 2400 ECC unregistered DIMMs for Dell PowerEdge T130, R230 and R330 servers

  • Capacity16GB (2 x 8GB)
  • Type288-Pin DDR4 SDRAM
  • SpeedDDR4 2400 (PC4 19200)
  • CAS LatencyCL17
  • Timing17-17-17
  • Voltage1.2V
  • ECC protection guards data integrity on Dell PowerEdge servers
  • DDR4 2400 speed with CL17 timing delivers responsive performance
  • 16 GB kit (2 × 8 GB) expands capacity up to 64 GB
  • 2 V unregistered DIMMs reduce power draw in 288-pin slots
  • Guaranteed compatibility with PowerEdge T130, R230 and R330 systems

Dell PowerEdge DDR4 kit

This 16 GB kit contains two 8 GB DDR4 ECC unregistered DIMMs rated at 2400 MHz with CL17 timings and 1.2 V operation. It is built for Dell PowerEdge T130, R330 and R230 servers that require 288-pin DDR4 memory with error correction. The modules use a 2Rx8 organisation and have no heat spreader.

Check slot count and maximum capacity

Each supported server provides four DDR4 slots and a 64 GB total limit, so this two-module kit occupies half the slots and leaves room for further expansion. Verify that the system BIOS is current and that the board accepts unregistered ECC DIMMs before ordering. The kit will not work in platforms that require registered or load-reduced modules.

Fits standard DDR4 server boards

The 288-pin form factor drops straight into any compatible DDR4 slot without adapters, freeing the remaining two slots for additional kits up to the 64 GB ceiling. ECC operation helps protect data integrity in always-on workloads, while the low 1.2 V draw keeps power demands modest. Buyers needing registered memory or capacities beyond 64 GB must choose a different product.

Kohokohdat

  • ECC protection guards data integrity on Dell PowerEdge servers
  • DDR4 2400 speed with CL17 timing delivers responsive performance
  • 16 GB kit (2 × 8 GB) expands capacity up to 64 GB
  • 2 V unregistered DIMMs reduce power draw in 288-pin slots
  • Guaranteed compatibility with PowerEdge T130, R230 and R330 systems

Tekniset tiedot

BrandComputer Memory Solutions
ModelCM1024722400ECCNR
Capacity16GB (2 x 8GB)
Type288-Pin DDR4 SDRAM
SpeedDDR4 2400 (PC4 19200)
CAS LatencyCL17
Timing17-17-17
Voltage1.2V
ECCYes
Buffered/RegisteredUnregistered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemDell Poweredge T130, Poweredge R330, Poweredge R230
Package Content2 Memory RAM Sticks

Kysymyksiä tästä tuotteesta

What comes in the box with the CM1024722400ECCNR kit and is anything else required?

The package contains two 8GB DDR4 ECC unregistered DIMM modules; no additional parts are needed for installation in a compatible Dell PowerEdge server.

Should I choose this 16GB (2x8GB) DDR4 2400 kit or a different capacity for my PowerEdge T130?

This kit provides 16GB using two of the four available slots; the T130 supports a maximum of 64GB, so you can add more modules later if your workload requires it.

What does the DDR4 2400 (PC4 19200) rating mean once the memory is installed in a PowerEdge R330?

The modules will run at up to 2400 MT/s with CL17 timing at 1.2V, delivering the rated bandwidth provided the system firmware configures them at that speed.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.