Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two green 240-pin DDR3 DIMM modules without heat spreaders

Computer Memory Solutions

Computer Memory Solutions CM5126410600DIMM 8GB (2x4GB) DDR3 1333 memory upgrade

SKU CH-843X-VT9ZS

8 GB kit of two 4 GB DDR3-1333 unbuffered DIMMs validated for HP Elite 8000 and 8100 small-form-factor and convertible minitower systems

  • Capacity8GB (2 x 4GB)
  • Type240-Pin DDR3 SDRAM
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL9
  • Timing9-9-9
  • Voltage1.5V
  • 8GB dual-channel kit upgrades system responsiveness
  • DDR3 1333 MHz speed matches platform specification
  • CL9 latency supports stable operation
  • 5 V standard voltage ensures compatibility
  • Designed for HP Elite 8100 and 8000 SFF systems

Ready for HP Elite 8000 and 8100 SFF

This 8 GB kit contains two 4 GB DDR3 modules built for HP Compaq Elite 8000 SFF, Elite 8000 Convertible Minitower, Elite 8100 SFF and Elite 8100 Convertible Minitower systems. It runs at 1333 MHz with CL9 timings at the standard 1.5 V. The unbuffered non-ECC DIMMs use major-brand chips and ship without heat spreaders.

Thermals power and noise in daily use

Standard DDR3 voltage keeps power draw low inside the small-form-factor chassis. Passive operation means no fan noise from the memory itself. The modules stay within the thermal envelope the original system was designed for.

Capacity limit decides fit

A 32-bit operating system caps usable memory at 4 GB while a 64-bit operating system allows the full 16 GB maximum across four slots. This 8 GB kit fills two slots and leaves room for further expansion if the OS supports it. Buyers limited to a 32-bit OS cannot use the full capacity.

Kohokohdat

  • 8GB dual-channel kit upgrades system responsiveness
  • DDR3 1333 MHz speed matches platform specification
  • CL9 latency supports stable operation
  • 5 V standard voltage ensures compatibility
  • Designed for HP Elite 8100 and 8000 SFF systems

Tekniset tiedot

BrandComputer Memory Solutions
ModelCM5126410600DIMM
Capacity8GB (2 x 4GB)
Type240-Pin DDR3 SDRAM
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL9
Timing9-9-9
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemHp/Compaq Elite 8100 Sff, Elite 8000 Sff Convt Minitower
Package Content2 Memory RAM Sticks

Kysymyksiä tästä tuotteesta

How do I install these 240-pin DDR3 modules into the HP Elite 8100 SFF and what step is often missed?

Power off the PC, open the chassis, align each module's notch with the slot key, press firmly until both retention clips click shut, then verify 8 GB is recognised in BIOS.

What maintenance or replacement will this 2 x 4 GB kit need over its service life?

No scheduled maintenance is required; the unbuffered non-ECC DDR3 sticks carry a limited lifetime warranty from Computer Memory Solutions, so replacement only occurs if a module fails.

What limit appears first when the Elite 8000 SFF runs sustained workloads with this 1333 MHz memory?

The platform caps at 16 GB with a 64-bit OS, so total capacity is the first ceiling reached before bandwidth or voltage limits become relevant.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.