Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

Computer Memory Solutions

Computer Memory Solutions CM5127210600ECCR2R4H 8GB (2x4GB) DDR3 1333 ECC Registered DIMM memory upgrade

SKU CH-SEE6-VYKKQ

ECC registered DDR3 kit for HP Z600 C2 workstations, 8 GB in two 4 GB modules at 1333 MHz

  • Capacity8GB (2 x 4GB)
  • Type240-Pin DDR3 SDRAM
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL9
  • Timing9-9-9
  • Voltage1.5V
  • 8GB kit expands workstation memory to 24GB or 48GB with dual CPUs
  • ECC registered design protects data integrity for server workloads
  • 1333MHz DDR3 speed matches Z600 C2 triple-channel architecture
  • 2Rx4 organisation enables full-channel population across six slots
  • 5V operation meets original HP Workstation Z600 C2 specifications

Targeted upgrade for HP Z600 C2 workstations

This 8 GB kit contains two 4 GB DDR3-1333 registered ECC DIMMs built specifically for the HP Compaq Workstation Z600 C2 revision. The modules run at 1.5 V with CL9 9-9-9 timing and use a 240-pin form factor. They are validated for the Intel 5520 chipset C2 stepping and will not function on earlier board revisions.

Replaces non-ECC or unbuffered memory in supported

The jump is worth it when the workstation requires registered ECC modules for error correction and the board carries the C2 revision of the Intel 5520 chipset. Mixing registered and unbuffered ECC DIMMs is not supported, so all populated slots must use matching registered parts. A 64-bit operating system is required to address more than 4 GB of memory.

Sustained operation with triple-channel interleaving

For best throughput under continuous load, populate all three channels per CPU with identical 2Rx4 modules. The system supports up to 48 GB of registered DIMMs with two CPUs installed. If only 4 GB modules are fitted, the OS may report as little as 3.5 GB usable depending on configuration. Matched x4 or x8 DRAM versions must not be mixed within the same bank.

Kohokohdat

  • 8GB kit expands workstation memory to 24GB or 48GB with dual CPUs
  • ECC registered design protects data integrity for server workloads
  • 1333MHz DDR3 speed matches Z600 C2 triple-channel architecture
  • 2Rx4 organisation enables full-channel population across six slots
  • 5V operation meets original HP Workstation Z600 C2 specifications

Tekniset tiedot

BrandComputer Memory Solutions
ModelCM5127210600ECCR2R4H
Capacity8GB (2 x 4GB)
Type240-Pin DDR3 SDRAM
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL9
Timing9-9-9
Voltage1.5V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemHp/Compaq Workstation Z600 C2
Package Content2 Memory RAM Sticks

Kysymyksiä tästä tuotteesta

Does the 240-pin DDR3 1333 registered DIMM fit the Z600 C2 motherboard slots?

Yes, the 240-pin DDR3 1333 registered DIMMs are keyed for the Z600 C2 workstation slots and require the C2 revision of the Intel 5520 chipset.

What is the correct way to install the 2Rx4 modules for triple-channel performance?

Install modules across all three memory channels per CPU for triple-channel interleaving; do not mix x4 and x8 DRAM versions within the same bank.

How often should the 1.5V registered ECC memory be checked for errors?

ECC corrects single-bit errors automatically; run a memory diagnostic if the system logs corrected errors or shows instability.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.