DELL
DELL 1.2TB 10K SAS 6G 2.5in internal hard drive
A 1.2TB 2.5in SAS drive spinning at 10000RPM with 64MB cache for compatible PowerEdge servers
- 2 TB capacity stores large enterprise datasets
- 10,000 RPM spindle delivers fast transactional throughput
- SAS 6 Gb/s interface connects directly to supported PowerEdge servers
- 64 MB cache buffers burst I/O workloads
- Validated for Dell PowerEdge M, R and T series platforms
Dell 1.2 TB 10K SAS drive
This Dell 1.2 TB internal hard drive spins at 10000 RPM and uses a 2.5 inch SAS 6Gb/s interface. It is built for Dell PowerEdge servers that require a 10K SAS small-form-factor drive. The 64 MB buffer supports consistent throughput in multi-drive arrays. It arrives new and matches part numbers HUC101212CSS600 and 0B28470.
Suits PowerEdge servers listed
This drive fits the PowerEdge M600, M610, M710, R610, R710, T610 and other models shown in the compatibility list. It is not for systems that lack a 2.5 inch SAS backplane or a controller that supports 6 Gb/s SAS signalling. Buyers needing a different physical size or interface protocol should look elsewhere.
10000 RPM rotational speed
The 10000 RPM spindle speed is the key specification that determines whether this drive meets the performance tier required by the target server. Lower-speed drives will not deliver the same transaction rate for database or virtualisation workloads. Verify that the server specification calls for 10K SAS before purchasing.
Kohokohdat
- 2 TB capacity stores large enterprise datasets
- 10,000 RPM spindle delivers fast transactional throughput
- SAS 6 Gb/s interface connects directly to supported PowerEdge servers
- 64 MB cache buffers burst I/O workloads
- Validated for Dell PowerEdge M, R and T series platforms
Tekniset tiedot
Tälle tuotteelle ei ole vielä julkaistu teknisiä tietoja.
Kysymyksiä tästä tuotteesta
What SAS controller or backplane is needed to run this 1.2TB 10000RPM drive?
A 2.5-inch SAS 6Gb/s backplane or HBA with a free drive bay and matching power connector is required.
Will this drive work in a PowerEdge R610 that already has 6G SAS drives installed?
Yes, the drive uses the same 2.5-inch SAS 6Gb/s interface and is listed for the R610, so it will operate alongside existing 6G SAS drives.
How can I verify the drive is recognised at full speed after installation?
Check the controller BIOS or OS utility to confirm the drive appears at 6Gb/s link speed, shows 1.2TB capacity and reports 10000RPM.
Myös tällä osastolla
Asiakkaat vertailivat myös näitä
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
