Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Silver 3.5 inch SATA hard drive with Dell label

DELL

DELL 400-AHID 8TB 3.5" SATA 7200 RPM internal hard drive

SKU CH-E816-CZPTK

8 TB 3.5" SATA internal hard drive spinning at 7200 RPM with a 128 MB buffer for Dell PowerEdge servers

  • InterfaceSATA 6.0Gb/s
  • Capacity8TB
  • RPM7200 RPM
  • Form Factor3.5"
  • 8 TB capacity stores large datasets and media libraries
  • 7200 RPM spindle speed delivers quick data access for demanding workloads
  • 128 MB buffer smooths burst transfers and improves sustained throughput
  • Hot-swap support enables drive replacement without server downtime
  • Validated for Dell PowerEdge R430 R630 R730 R730xd T430 T630 servers

Dell 400-AHID 8TB 3.5" SATA Drive

The Dell 400-AHID is an 8TB 3.5-inch internal hard drive spinning at 7200 RPM over a SATA 6.0Gb/s interface. It is built for Dell PowerEdge servers such as the R430, R630, R730, R730XD, T430 and T630 where high-capacity bulk storage is required. The 128 MB buffer helps sustain throughput for sequential workloads.

Hot-swap tray and Dell firmware

The drive ships in a hot-swap carrier that matches the drive bays of the listed PowerEdge models, allowing removal and insertion without powering down the chassis. Dell-specific firmware is pre-loaded to ensure correct reporting to the iDRAC management controller and to the RAID controller’s drive health monitoring. Retail or OEM packaging may vary but the carrier and firmware remain the same.

Tool-less bay installation

Installation consists of sliding the carrier into an empty 3.5-inch hot-swap bay until the latch engages; no screws or cables are needed because power and data connect through the backplane. The most common issue is inserting the drive into a bay whose backplane or RAID controller does not support 8TB SATA drives, which prevents the system from recognising the volume. Verifying the server’s drive-count limit and controller firmware beforehand avoids this problem.

Kohokohdat

  • 8 TB capacity stores large datasets and media libraries
  • 7200 RPM spindle speed delivers quick data access for demanding workloads
  • 128 MB buffer smooths burst transfers and improves sustained throughput
  • Hot-swap support enables drive replacement without server downtime
  • Validated for Dell PowerEdge R430 R630 R730 R730xd T430 T630 servers

Tekniset tiedot

BrandDell
Model400-AHID
InterfaceSATA 6.0Gb/s
Capacity8TB
RPM7200 RPM
Form Factor3.5"

Kysymyksiä tästä tuotteesta

Will the 128 MB buffer on the Dell 400-AHID need any firmware updates or replacement over time?

The 128 MB buffer is a fixed hardware component on the drive and does not require maintenance or replacement; firmware updates for Dell drives are typically handled through the server's lifecycle controller if the vendor releases them.

What is the first limit the 7200 RPM spindle speed hits during sustained write workloads?

Sustained write performance is ultimately capped by the 7200 RPM mechanical latency and the SATA 6.0 Gb/s interface throughput ceiling.

How much heat and power does the 8TB 3.5" SATA drive draw when running continuously in a PowerEdge server?

The drive is designed for hot-swap server bays where chassis airflow manages heat; power draw varies by workload but stays within standard 3.5" enterprise SATA limits.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.