DELL
DELL 400-AUWY 4TB 7.2K SATA 3.5 internal hard drive
A 4 TB, 7.2 K RPM SATA hard drive in a 3.5 inch form factor for Dell PowerEdge servers
- 4 TB capacity stores large data sets
- 2K RPM spindle delivers steady throughput
- SATA 6 Gbps interface connects to standard controllers
- 5-inch LFF form factor fits enterprise bays
- Hot-swap support simplifies drive replacement
Dell 4TB 7.2K SATA 3.5 HDD
This Dell 400-AUWY is a 4TB 3.5-inch internal hard drive spinning at 7.2K rpm with a SATA 6Gbps interface. It is built for Dell PowerEdge servers and ships in a hot-swap large form factor tray. The unit is new and carries Dell Enterprise branding.
Suits PowerEdge storage arrays.
This drive fits Dell PowerEdge servers that accept 3.5-inch hot-swap trays, making it a direct match for capacity upgrades in those chassis. Buyers who need a drive for a standard desktop, a laptop, or a non-Dell enclosure without the correct tray should look elsewhere. The tray sticker may not be included depending on stock.
4TB capacity and 7.2K rpm spindle speed
The single specification that decides fit is the 4TB capacity combined with a 7.2K rpm spindle speed on a SATA interface. This balance of density and rotational speed targets bulk storage workloads in compatible Dell PowerEdge systems. Verify the server tray requirement before purchase.
Kohokohdat
- 4 TB capacity stores large data sets
- 2K RPM spindle delivers steady throughput
- SATA 6 Gbps interface connects to standard controllers
- 5-inch LFF form factor fits enterprise bays
- Hot-swap support simplifies drive replacement
Tekniset tiedot
Tälle tuotteelle ei ole vielä julkaistu teknisiä tietoja.
Kysymyksiä tästä tuotteesta
Will the 400-AUWY 4TB drive work with my older SATA controller that only supports 3 Gbps?
The drive uses a SATA 6 Gbps interface and will negotiate down to 3 Gbps on older controllers, so it will function at the lower speed.
How can I verify the 7.2K RPM drive is performing correctly after installation?
Check the BIOS or operating system device manager to confirm the drive is detected at 4TB capacity and running on a SATA link.
Does the 3.5 LFF hot-swap drive ship with a mounting tray and screws, or do I need to order them separately?
The tray sticker may not be included and the drive is sold without a tray; you must supply a compatible Dell PowerEdge hot-swap tray for your server model.
Myös tällä osastolla
Asiakkaat vertailivat myös näitä
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
