DELL
DELL H6GCD 800GB SAS 2.5 enterprise SSD
800 GB SAS enterprise SSD for Dell PowerEdge servers, dual-port 12/24 Gbps write-intensive TLC in 2.5 inch form factor
- InterfaceSAS
- 800 GB capacity supports large enterprise workloads
- SAS 12/24 Gbps interface delivers high-throughput data transfer
- Write-intensive TLC NAND handles sustained write workloads
- 5 inch form factor fits standard server drive bays
- Compatible with Dell PowerEdge R640, R740, R750 and many other models
800 GB SAS enterprise SSD
This Dell H6GCD solid-state drive delivers 800 GB of write-intensive TLC storage over a dual-rate SAS interface. It is built for servers that need consistent low-latency performance under heavy write workloads such as databases or virtualisation clusters.
2.5 inch form factor with hot-plug tray
The drive uses the standard 2.5 inch enterprise carrier so it slides directly into compatible PowerEdge bays without adapters. SAS 12/24 Gbps signalling works with existing backplanes and controllers, simplifying upgrades in dense rack or tower chassis.
Optimised for sustained write traffic
Write-intensive TLC NAND and updated firmware maintain steady throughput during continuous logging or caching duties. The dual-speed SAS link negotiates the highest rate the backplane supports, keeping power draw predictable in normal server operation.
Kohokohdat
- 800 GB capacity supports large enterprise workloads
- SAS 12/24 Gbps interface delivers high-throughput data transfer
- Write-intensive TLC NAND handles sustained write workloads
- 5 inch form factor fits standard server drive bays
- Compatible with Dell PowerEdge R640, R740, R750 and many other models
Tekniset tiedot
| Brand | Dell |
|---|---|
| Model | H6GCD, KPM6XMUG800G |
| Interface | SAS |
Kysymyksiä tästä tuotteesta
Does the 12/24Gbps SAS interface cap throughput at the lower speed on older controllers?
The drive negotiates at 12Gbps or 24Gbps depending on the host controller; older controllers will limit it to 12Gbps in practice.
What physical bay and form factor does the 2.5-inch SSD require?
It fits a standard 2.5-inch SAS hot-plug bay in any listed PowerEdge server; the drive uses the common SFF form factor.
How is the drive installed, and what step is often missed?
Slide the SSD into the hot-plug tray until it clicks, then insert the tray into the server bay; the step often missed is fully seating the tray latch to engage the SAS connector.
Myös tällä osastolla
Asiakkaat vertailivat myös näitä
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
