DELL
DELL ST4000NM0033 4TB 7.2K 3.5" SATA internal hard drive
3.5-inch 4 TB SATA hard drive spinning at 7 200 rpm for Dell R630, R710, R715 and R720 servers
- 4 TB capacity stores large data sets
- 7200 RPM rotation speed delivers responsive throughput
- SATA III interface connects to standard ports
- 5 inch form factor fits desktop bays
- Compatible with R630 R710 R715 R720 servers
Designed for Dell PowerEdge servers
This 3.5-inch SATA hard drive delivers four terabytes of storage at 7200 RPM. It is built to fit Dell PowerEdge R630, R710, R715 and R720 systems. The drive uses a standard SATA III interface for direct integration into compatible drive bays.
Suits nearline storage arrays.
IT teams expanding bulk capacity in supported PowerEdge chassis will find the drive matches the required form factor and spindle speed. Environments demanding low latency or sustained random access should evaluate solid-state alternatives instead.
Maintains steady throughput under continuous duty
The 7200 RPM spindle sustains sequential transfer rates during long write or rebuild operations. Rotational vibration tolerance helps keep performance consistent when multiple drives operate in the same chassis.
Kohokohdat
- 4 TB capacity stores large data sets
- 7200 RPM rotation speed delivers responsive throughput
- SATA III interface connects to standard ports
- 5 inch form factor fits desktop bays
- Compatible with R630 R710 R715 R720 servers
Tekniset tiedot
Tälle tuotteelle ei ole vielä julkaistu teknisiä tietoja.
Kysymyksiä tästä tuotteesta
Will this 3.5" SATA III drive fit in a standard desktop 3.5" bay with a SATA data and power cable?
Yes, the drive uses the 3.5" form factor and SATA III interface, so it connects to any standard desktop 3.5" bay using ordinary SATA data and power cables.
Can I run this 7200RPM SATA III drive on an older motherboard that only supports SATA II?
The drive is SATA III and will negotiate down to SATA II speeds on an older controller, so it will work but transfer rates will be limited to the SATA II maximum.
After installing the 4TB ST4000NM0033, how can I verify it is running at 7200RPM?
Check the drive’s reported rotation speed in BIOS/UEFI or with a tool such as CrystalDiskInfo; it should show 7200RPM for this model.
Myös tällä osastolla
Asiakkaat vertailivat myös näitä
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
