Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Standard 3.5 inch silver internal hard drive with circuit board visible

Epoch

Epoch 61V26 8TB 7200 RPM SATA 3.5" internal hard drive

SKU CH-MEWG-HGVJG

An 8 TB, 7200 RPM SATA 3.5-inch drive built for Dell PowerEdge 12, 13 and 14 generation servers

  • InterfaceSATA
  • Capacity8TB
  • RPM7200 RPM
  • UsageIdeal for Servers
  • Form Factor3.5"
  • 8 TB capacity stores large server datasets
  • 7200 RPM spindle speed delivers responsive throughput
  • SATA 6 Gb/s interface fits standard 3.5" bays
  • Tested for Dell PowerEdge 12 13 14 generation servers
  • 3 year warranty covers drive replacement

Epoch 61V26 8TB SATA server drive

This Epoch 61V26 kit supplies an 8TB 3.5-inch hard drive that spins at 7200 RPM over a SATA 6Gb/s interface. It is built for Dell PowerEdge generation 12 and 13 servers as well as Dell Tower generation 12 and 14 servers. The drive arrives new in retail or OEM packaging.

Suited for SATA server bays

The drive fits the listed Dell PowerEdge R and T models from generations 12 and 13 plus Tower models from generations 12 and 14. Builders whose chassis or controller require a different interface or a smaller form factor should look at another part.

8TB capacity at 7200 RPM

The single specification that decides fit is the 8TB capacity combined with 7200 RPM spindle speed on a SATA 6Gb/s link. This capacity and speed profile matches the workloads the listed Dell servers are designed to handle.

Kohokohdat

  • 8 TB capacity stores large server datasets
  • 7200 RPM spindle speed delivers responsive throughput
  • SATA 6 Gb/s interface fits standard 3.5" bays
  • Tested for Dell PowerEdge 12 13 14 generation servers
  • 3 year warranty covers drive replacement

Tekniset tiedot

InterfaceSATA
Capacity8TB
RPM7200 RPM
UsageIdeal for Servers
Form Factor3.5"

Kysymyksiä tästä tuotteesta

How do I install the 3.5" SATA drive in a Dell PowerEdge R720 server and what step is often missed?

Slide the drive into the hot-swap bay until the carrier clicks, then secure the latch; the step often missed is fully engaging the latch so the SATA connector seats on the backplane.

What maintenance or replacement will the 7200 RPM SATA drive need later?

Plan to replace the drive after its rated service life or if SMART attributes show reallocated sectors; no scheduled mechanical maintenance is required for the sealed 3.5" unit.

What limit appears first on the 8TB SATA drive under sustained server workloads?

The 6 Gb/s SATA interface and 7200 RPM spindle speed cap sustained throughput, so sequential transfer rate hits the interface ceiling before the 8TB capacity fills.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.