NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
EVGA
750 W ATX power supply with a single +12 V rail and non-modular cables, 80 PLUS Bronze certified for 100–240 V input at 50/60 Hz
The EVGA 100-N1-0750-L1 delivers 750 W from a single +12V rail in a standard ATX form factor. It holds 80 PLUS Bronze certification and accepts 100-240 V input at 50/60 Hz. Fixed cables simplify installation in budget-focused builds.
Builders assembling a mid-range desktop with a single graphics card will find the wattage and rail layout adequate. Systems requiring detachable cables for tight routing or higher efficiency ratings need a different unit. Multi-GPU configurations or servers demanding redundant power should also consider other options.
The single +12V rail supplies the full 750 W to CPU and GPU without manual load balancing. Bronze-rated efficiency reduces waste heat compared to unrated designs while keeping cost down. This rail topology is the key spec that determines compatibility with typical enthusiast components.
| Brand | EVGA |
|---|---|
| Part Number | 100-N1-0750-L1 |
| Type | ATX |
| Maximum Power | 750 W |
| +12V Rails | Single |
| Modular | Non-Modular |
| Energy-Efficient | 80 PLUS BRONZE Certified |
| Input Frequency Range | 50/60 Hz |
| Input Voltage | 100 - 240 V |
The unit carries 80 PLUS BRONZE certification, meaning it meets defined efficiency targets at typical loads, which reduces waste heat and allows the fan to run at lower speeds during extended operation.
A standard ATX mounting cut-out and a motherboard with 24-pin ATX and 4+4-pin EPS power sockets are required; the fixed cable harness connects directly to those headers.
A single +12 V rail delivers the full 750 W across all 12 V consumers, so legacy hard drives, PCIe cards and CPU power connectors all draw from the same stable voltage source without rail-balancing concerns.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?