Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
A standard ATX power supply unit with a single fan and matte metal casing

Gulfe

Gulfe ATX Power Supply 5.9" Depth 2.5kg

SKU CH-NKR0-WY5XR

ATX power supply with reduced 5.9" depth, dual-voltage input and multiple SATA connectors for legacy desktop builds

  • TypeATX
  • Fans1
  • Weight2.5
  • Replaces legacy HP Pavilion H8-1012C and H8-1050Z units
  • Reduced 5.9" depth fits compact ATX cases
  • Over current and over power protection safeguards components
  • High efficiency design lowers energy waste
  • 24-pin ATX, 4-pin P4, three SATA, two LP4, one floppy connectors

Replacement for HP Pavilion Elite H8-1012C

This ATX power supply is built as a direct replacement for the HP Pavilion Elite H8-1012C and H8-1050Z desktop PCs. It delivers the standard output rails including +5V, -5V, +12V1, +12V2, +3.3V, -12V and +5V-SB. The unit includes a 24-pin ATX connector, a 4-pin P4-12V connector, three SATA power connectors, two LP4 connectors and a floppy connector. Its reduced depth of 5.9 inches helps it fit into tighter chassis layouts.

Sustained load behaviour

The supply is Hi-Pot tested and specified for low ripple and noise across its operating range. Hold-up time is rated at a minimum of 17 ms at nominal input, providing a brief buffer during momentary power interruptions. Rise time is less than 70 ms, so output voltages reach regulation quickly when the system powers on. Over current and over power protection circuits are present to shut the unit down if limits are exceeded during prolonged heavy demand.

Thermals noise and power draw

A single fan provides cooling for the 2.5 kg unit. The supply accepts AC input from 110 to 220 V at 47 to 63 Hz, covering both 115 V and 230 V mains without manual switching. High efficiency is claimed by the manufacturer, reducing waste heat under typical loads. Dimensions are 5.86 inches by 3.3 inches, contributing to the compact profile that aids airflow in restricted spaces.

Kohokohdat

  • Replaces legacy HP Pavilion H8-1012C and H8-1050Z units
  • Reduced 5.9" depth fits compact ATX cases
  • Over current and over power protection safeguards components
  • High efficiency design lowers energy waste
  • 24-pin ATX, 4-pin P4, three SATA, two LP4, one floppy connectors

Tekniset tiedot

BrandGulfe
TypeATX
Fans1
Weight2.5

Kysymyksiä tästä tuotteesta

How much noise and heat does the single fan produce during continuous operation?

The unit uses one fan to move air through the reduced-depth chassis; the supplier notes low ripple and noise but does not publish a decibel or thermal rating.

Which connectors must my motherboard and drives already provide for this PSU to plug in?

It requires a 24-pin ATX socket, a 4-pin P4 12 V header, three SATA power ports, two LP4 peripheral plugs and one floppy-style connector.

Will the 5.86-inch depth and 2.5 kg weight fit the HP Pavilion Elite H8-1012C and H8-1050Z chassis I am keeping?

The reduced 5.86-inch depth matches the legacy HP models listed, and the 2.5 kg mass is consistent with the original supply form factor.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.