Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Standard ATX power supply unit with single cooling fan and matte black metal casing

Gulfe

Gulfe ATX Power Supply Replacement HP Pavilion Elite HPE H8-1020C

SKU CH-SXTQ-R6274

ATX power supply with reduced depth, single fan, 24-pin, 4-pin CPU, three SATA, two LP4 and one floppy connector, plus over-current and over-power protection

  • TypeATX
  • Fans1
  • Weight2.5
  • Replaces several legacy HP power supplies
  • ATX reduced depth fits tighter chassis spaces
  • Dual-voltage 115/230 V input works worldwide
  • Over-current and over-power protection safeguards components
  • 24-pin ATX, 4-pin CPU, three SATA connectors included

Gulfe ATX replacement for HP Pavilion Elite HPE

This Gulfe ATX power supply is built as a direct replacement for the HP Pavilion Elite HPE H8-1020C desktop. It delivers the standard output rails of +5V, -5V, +12V1, +12V2, +3.3V, -12V and +5V-SB. The unit includes over-current and over-power protection and is hi-pot tested for low ripple and noise.

Reduced-depth ATX form factor fits legacy chassis

The supply uses a reduced-depth ATX design measuring 5.86 inches by 3.3 inches, shorter than many older legacy units it replaces. This smaller footprint increases compatibility inside compact or older cases where a full-length PSU would not fit. It accepts 110/220 V AC input at 47-63 Hz and provides a hold-up time of 17 ms minimum at nominal load.

Verify connector needs

Check that your motherboard requires the 24-pin ATX (20+4) connector and a single P4 4-pin CPU power plug. The unit supplies three SATA 15-pin connectors, two LP4 4-pin connectors and one floppy 4-pin connector. Ensure the 5.9-inch height and 3.4-inch width clear your case interior and that the single fan orientation matches your airflow path.

Kohokohdat

  • Replaces several legacy HP power supplies
  • ATX reduced depth fits tighter chassis spaces
  • Dual-voltage 115/230 V input works worldwide
  • Over-current and over-power protection safeguards components
  • 24-pin ATX, 4-pin CPU, three SATA connectors included

Tekniset tiedot

BrandGulfe
TypeATX
Fans1
Weight2.5

Kysymyksiä tästä tuotteesta

Will the 5.86-inch depth fit my HP Pavilion Elite HPE H8-1020C case?

The unit measures 5.86 inches deep and 3.3 inches wide, matching the reduced-depth ATX form factor specified for the H8-1020C chassis.

Which power connectors must I attach during installation, and which one is most often missed?

Connect the 24-pin ATX, the 4-pin P4-12V, three SATA, two LP4 and one floppy connector; the 4-pin P4-12V near the CPU socket is the step most frequently overlooked.

The fan is the only moving part — how do I keep it running cleanly over time?

Blow dust out of the single intake fan every few months with compressed air; the 17 ms hold-up time and over-current protection remain effective as long as airflow stays clear.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.