HPE
HPE 877788-B21 1.92 TB 2.5" SATA internal solid state drive
1.92 TB 2.5-inch SATA internal SSD with 600 MB/s interface for HPE ProLiant XL170r Gen10 server
- 92 TB capacity stores large datasets
- SATA 600 interface delivers 6 Gbit/s throughput
- 5 inch form factor fits standard drive bays
- Designed for HPE ProLiant XL170r Gen10 servers
- New condition ensures full manufacturer reliability
HPE 1.92 TB SATA 2.5" server SSD
This HPE solid-state drive delivers 1.92 TB of storage in a 2.5-inch internal form factor. It connects via a SATA interface operating at the SATA/600 standard. The drive is designed for server environments and carries the manufacturer part number 877788-B21.
Suits HPE ProLiant XL170r Gen10 server upgrades
This drive is validated for the HPE ProLiant XL170r Gen10 server, making it a direct fit for that platform. It is not suitable for desktop PCs or laptops that require consumer-grade firmware. Buyers needing wireless connectivity should look elsewhere as this drive has no wireless LAN capability.
SATA/600 interface determines host compatibility
The drive uses the SATA/600 interface standard, so the host system must provide a matching SATA port. This single specification decides whether the drive can be installed and used. Verify that your server backplane or controller supports this interface before purchase.
Kohokohdat
- 92 TB capacity stores large datasets
- SATA 600 interface delivers 6 Gbit/s throughput
- 5 inch form factor fits standard drive bays
- Designed for HPE ProLiant XL170r Gen10 servers
- New condition ensures full manufacturer reliability
Tekniset tiedot
| Brand | HPE |
|---|
Kysymyksiä tästä tuotteesta
Does my server need a 2.5" SATA drive bay to install this drive?
Yes, the drive uses a 2.5" form factor and connects through a SATA/600 interface, so a compatible 2.5" SATA bay is required.
Will this 1.92 TB SATA SSD work in an HPE ProLiant XL170r Gen10 server alongside existing mechanical drives?
It is listed as compatible with the HPE ProLiant XL170r Gen10 and uses the standard SATA/600 interface, allowing it to operate alongside other SATA drives in that server.
How can I verify the drive is recognised at full 1.92 TB capacity after installation?
Check the server BIOS or operating system disk management to confirm the drive appears with its full 1.92 TB capacity and reports a SATA/600 link speed.
Myös tällä osastolla
Asiakkaat vertailivat myös näitä
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
