Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Rectangular ATX power supply unit with matte black finish and cooling fan grille

KHACHIMO

KHACHIMO ATX Power Supply 5V 24A 3.3V 30A 80 PLUS Gold

SKU CH-JH61-D9CV6

ATX power supply delivering 5 V at 24 A and 3.3 V at 30 A with 80 PLUS Gold efficiency and zero-RPM fan mode for silent low-load operation

  • TypeATX
  • Modern Standby support gives extremely fast wake-from-sleep and better low-load efficiency
  • 80 PLUS Gold certification delivers high efficiency for lower power use, less noise and cooler temps
  • Zero RPM fan mode stops the fan at low and medium loads for near-silent operation
  • Resonant LLC topology with DC-to-DC conversion provides clean power, reduces coil whine and enables efficient sleep states
  • ATX form factor with 5 V 24 A and 3.3 V 30 A rails fits TYCO Plate 632AE CPC-A builds

ATX PSU for TYCO Plate

This ATX power supply is built specifically for the TYCO Plate platform and delivers 5 V at 24 A and 3.3 V at 30 A. It carries 80 PLUS Gold certification for high efficiency and lower heat output. Modern Standby compatibility enables extremely fast wake-from-sleep times and improved low-load efficiency.

Suits quiet, efficient TYCO builds

Builders who need an ATX unit that matches the TYCO Plate's voltage rails and want near-silent operation at low and medium loads will benefit from the Zero RPM fan mode. The resonant LLC topology with DC-to-DC conversion reduces coil whine and supports deeper sleep states. Systems requiring different rail currents or a non-ATX form factor should look elsewhere.

Fits standard ATX layouts

The unit slots into a regular ATX mounting pattern and uses the resonant LLC plus DC-to-DC design to provide clean, consistent power across the 5 V and 3.3 V rails. Zero RPM mode frees the build from fan noise during light workloads, while Modern Standby support lets the system enter and exit low-power states quickly. Ensure the chassis accommodates a standard ATX power supply and that the TYCO Plate's connector pinout matches the unit's output.

Kohokohdat

  • Modern Standby support gives extremely fast wake-from-sleep and better low-load efficiency
  • 80 PLUS Gold certification delivers high efficiency for lower power use, less noise and cooler temps
  • Zero RPM fan mode stops the fan at low and medium loads for near-silent operation
  • Resonant LLC topology with DC-to-DC conversion provides clean power, reduces coil whine and enables efficient sleep states
  • ATX form factor with 5 V 24 A and 3.3 V 30 A rails fits TYCO Plate 632AE CPC-A builds

Tekniset tiedot

TypeATX

Kysymyksiä tästä tuotteesta

Which motherboard power connector does this unit provide for a TYCO Plate system?

The supply is built for the TYCO Plate platform and delivers 5 V at 24 A and 3.3 V at 30 A through its ATX connector, so the motherboard must accept standard ATX pin-out with those rail ratings.

Will the fan stay off when the PC is idle alongside older components that draw little power?

Zero RPM Fan Mode stops the fan completely at low and medium loads, so legacy parts that only sip power will not spin the fan up.

How can I verify the 80 PLUS Gold efficiency is active after installation?

Check the 80 PLUS Gold badge on the unit and observe lower waste heat and quieter running at typical desktop loads compared with a non-certified supply.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.